Search

Biomass gasification for energy purposes has several advantages, such as the mitigation of global warming and national energy independency. In the present work, the data from an innovative and intensified steam/oxygen biomass gasification process, integrating a gas filtration step directly inside the reactor, are presented. The produced gas at the outlet of the 1 MWth gasification pilot plant was analysed in terms of its main gaseous products (hydrogen, carbon monoxide, carbon dioxide, and methane) and contaminants. Experimental test sets were carried out at 0.25–0.28 Equivalence Ratio (ER), 0.4–0.5 Steam/Biomass (S/B), and 780–850 °C gasification temperature. Almond shells were selected as biomass feedstock and supplied to the reactor at approximately 120 and 150 kgdry/h. Based on the collected data, the in-vessel filtration system showed a dust removal efficiency higher than 99%-wt. A gas yield of 1.2 Nm3dry/kgdaf and a producer gas with a dry composition of 27–33%v H2, 23–29%v CO, 31–36%v CO2, 9–11%v CH4, and light hydrocarbons lower than 1%v were also observed. Correspondingly, a Low Heating Value (LHV) of 10.3–10.9 MJ/Nm3dry and a cold gas efficiency (CGE) up to 75% were estimated. Overall, the collected data allowed for the assessment of the preliminary performances of the intensified gasification process and provided the data to validate a simulative model developed through Aspen Plus software.

This paper addresses the study of a pyro-gasification plant designed, built, and operated to recover inert metals from different types of solid waste. Experimental tests were carried out using pulper as the solid waste. However, while a reliable composition analysis of the produced syngas was carried out, a precise composition evaluation of the pulper used during the experimental activities was not performed and the related data were characterized by unacceptable uncertainty. Therefore, with the aim of reliably characterizing the plant operation, a thermochemical model of the gasification process was setup to simulate the equilibrium operation of the plant and a vector optimization methodology was used to calibrate the numerical model. Then, a decision-making problem was solved to identify the most suitable optimal solution between those belonging to the Pareto optimal front, thus obtaining reliable composition data for the adopted pulper waste. In particular, four different identification criteria were applied for the selection of small subset of solutions over the 3138 dominant solutions found. Among them, the solution (i.e., set of calibration parameters) that minimizes the experimental-numerical difference between the lower heating value of the produced syngas seemed to provide the most reliable approximation of the real plant operation. Finally, a possible plant configuration is proposed for the energetic valorization of the pulper waste and its overall conversion process efficiency is estimated.

This paper explores a possible waste-based economy transition strategy. Digestate from the organic fraction of municipal solid waste (OFMSW) is considered, as well as a low-added value product to be properly valorized. In this regard, air gasification may be used to produce syngas. In this work, the production of methanol, hydrogen, or electricity from digestate-derived syngas was assessed by ChemCAD process simulation software. The process scheme of methanol production comprises the following parts: water gas shift (WGS) with carbon capture and storage units (CCS), methanol synthesis, and methanol purification. In the case of hydrogen production, after WGS-CCS, hydrogen was purified from residual nitrogen by pressure swing absorption (PSA). Finally, for electricity production, the digestate-derived syngas was used as fuel in an internal combustion engine. The main objective of this work is to compare the proposed scenarios in terms of CO2 emission intensity and the effect of CO2 storage. In particular, CCS units were used for methanol or hydrogen production with the aim of obtaining high equilibrium yield toward these products. On the basis of 100 kt/year of digestate, results show that the global CO2 savings were 80, 71, and 69 ktCO2eq/year for electricity, methanol, and hydrogen production, respectively. If carbon storage was considered, savings of about 105 and 99 ktCO2eq/year were achieved with methanol and hydrogen production, respectively. The proposed scenarios may provide an attractive option for transitioning into methanol or hydrogen economy of the future.