Search

This paper reports quasi-static and low-kinetic energy impact testing of auxetic and conventional open-cell polyurethane foams. The auxetic foams were fabricated using the established thermo-mechanical process originally developed by Lakes. Converted foams were subject to compression along each dimension to 85% and 70% of the unconverted dimension during the conversion process, corresponding to linear compression ratios of 0.85 and 0.7, respectively. The 0.7 linear compression ratio foams were confirmed to have a re-entrant foam cell structure and to be auxetic. Impact tests were performed for kinetic energies up to 4 J using an instrumented drop rig and high speed video. A flat dropper was employed on isolated foams, and a hemispherical-shaped dropper on foams covered with a rigid polypropylene outer shell layer. The flat dropper tests provide data on the rate dependency of the Poisson's ratio in these foam test specimens. The foam Poisson's ratios were found to be unaffected by the strain rate for the impact energies considered here. Acceleration-time data are reported along with deformation images from the video footage. The auxetic samples displayed a six times reduction in peak acceleration, showing potential in impact protector devices such as shin or thigh protectors in sports equipment applications. [ABSTRACT FROM AUTHOR]

This paper describes the fabrication of polymeric auxetic foam using a quasi tri‐axial compression method. In this method, the conversion process is executed by applying a quasi tri‐axial compression on conventional closed‐cell polyurethane foams. In order to achieve optimum auxetic characteristics, the densification points in various directions are evaluated. In addition, the heating time of the compressed foam is also determined and applied to minimize the residual stress due to the volumetric compression. It leads to the fabrication of auxetic foams with achievable maximum re‐entrancy and minimum collapsed cells without surface creasing. The results also show that the optimized auxetic foam exhibits isotropic behavior compared to its pre‐cursor foam as verified by the morphological analysis. The produced foam has all the desired properties of auxetic foams. The auxetic foam with a negative Poisson's ratio may be have great potential as the supplementary materials in energy absorption and structural applications. [ABSTRACT FROM AUTHOR]

The utility of auxetic materials in applications such as foams and composites is contingent upon the performance of these materials under cyclic loading. Recently, several textile materials (knitted, woven, and nonwoven fabrics) have been found to exhibit auxetic properties, either through design and/or the use of a postprocessing treatment. In the wake of these advancements, this research examines the reversibility of the out‐of‐plane auxetic response in previously studied polyester fiber needle‐punched nonwovens. Herein, a heat‐compressed nonwoven is strained cyclically to different levels, and the thickness is measured before and after straining. While axial extension is found to be elastic for up to 3% strain, thickness increases (auxetic responses) are almost completely reversible for 1% axial strain and highly reversible for 2% and 3% axial strain. Irreversible changes can be clearly observed starting at strains of 2% and larger, especially for a higher number of cycles. Combining these results with the previous understanding from microscopic and tomographic imaging, possible reversible (straightening of bent fibers and fiber bundles) and irreversible (slipping or breaking of fibers) structural deformations leading to thickness changes are identified. These processes influence the magnitude of the auxetic response within and beyond the elastic strain regime, respectively. [ABSTRACT FROM AUTHOR]