Search

Porous silica-based adsorbents for hexavalent chromium (Cr(VI)) ion removal were prepared by the combined use of functionalization with (3-glycidyloxypropyl)trimethoxysilane and the grafting of branched and linear polyethyleneimine (BPEI and LPEI). LPEI was prepared from polyethyloxazolin by hydrolysis with HCl. The preparation of LPEI was identified by NMR measurements and the grafting of BPEI and LPEI on the silica beads was confirmed by an XPS analysis. The Cr(VI) ion adsorption of the obtained BPEI-grafted silica beads (BPEI–silica beads) was investigated as a function of the pH value, the content of amino groups, the temperature, the Cr(VI) ion concentration, and the molecular mass of the grafted BPEI chains. The Cr(VI) ion adsorption at pH 3.0 increased with an increase in the content of amino groups, and the maximum adsorption capacity of 1.06 mmol/g was obtained when the content of amino groups was at 2.17 mmol/g. This value corresponds to 589 mg/g−1.8KPEI, and the adsorption ratio of about 0.5 is a noteworthy result. The data fit to the pseudo-second-order kinetic model, and the suitability of this fitting was supported by the results that the adsorption capacity and initial rate of adsorption increased with the temperature. In addition, the equilibrium data followed the Langmuir isotherm model. These results clearly demonstrate that the Cr(VI) adsorption occurred chemically, or through the electrostatic interaction of protonated amino groups on the grafted BPEI chains with hydrochromate (HCrO4−) ions. A higher adsorption capacity was obtained for the silica beads grafted with shorter BPEI chains, and the adsorption capacity of BPEI–silica beads is a little higher than that of linear PEI-grafted silica beads, suggesting that the Cr(VI) ion adsorption is affected by the chain isomerism of PEI (linear and branched) as well as the molecular mass of the grafted PEI chains, in addition to the content of amino groups. The experimental and analytical results derived from this study emphasize that the BPEI–silica beads can be used as an adsorbent for the removal of Cr(VI) ions from an aqueous medium.

Porous cellulose beads were quaternized with glycidyltrimethylammonium chloride (GTMAC) to explore a potential use of them as an adsorbent for removal of humic acid (HA) from aqueous medium. The introduction of quaternary ammonium groups was confirmed by FT-IR and XPS analysis. The content of introduced quaternary ammonium groups increased with an increase in the GTMAC concentration. The adsorption capacity increased with a decrease in the initial pH value and attained the maximum value at pH 3 and increased with an increase in the content of quaternary ammonium groups. The removal % increased with the dose of quaternized cellulose beads at both pH 3.0 and 6.0. The adsorption process obeyed the pseudo-second order kinetic model and exhibited a better fit to the Langmuir isotherm model, suggesting that the adsorption of HA is accomplished through the electrostatic interaction between a quaternary ammonium group introduced and a dissociated carboxy group of a HA molecule. The maximum adsorption capacity obtained in this study is comparable to or higher than those published by other articles. HA loaded was completely released to NaOH solutions at higher than 100 mM to regenerate the quaternized cellulose beads. The above-mentioned results clearly show that the quaternized cellulose beads prepared in this study can be used as a regenerable adsorbent with high capacity for removal of HA from aqueous medium.