Search

Photonic crystal reflector (PCR) membranes exhibit a resonantly enhanced normal-incidence reflectivity. Many applications require this resonance to occur at a specific wavelength, however, imposing geometrical tolerances that are not reliably achieved with standard nanolithography. Here we finely tune the resonant wavelength of a freestanding Si 3 N 4 PCR membrane with iterative hydrofluoric acid etches, achieving a 57 nm thin crystal with a resonant wavelength 0.15 nm (0.04 linewidths) away from our target (1550 nm). This thin crystal exhibits a broader, shallower transmission dip than its simulated response to plane waves, and we identify two causes related to beam collimation. Finally, we present a series of simulations and general design considerations for realizing robust, high-reflectivity resonances.

In this Letter, a novel all-polymer arrayed waveguide grating (AWG) device with an operating wavelength around 850 nm is reported. The all-polymer AWG consists of polymer ridge waveguides fabricated on a thin poly(methyl methacrylate) foil via microscope projection photolithography. The developed device is suitable to be integrated into optical circuits, e.g., a planar polymer foil and, along with other optical integrated devices, to be used for different sensing applications. The functionality of the device is demonstrated by using a fiber Bragg grating sensor and performing strain measurements.

Waveguide writing in poly (methyl methacrylate) (PMMA) with femtosecond laser radiation is presented. An adequate refractive index change is induced in the border area below the irradiated focal volume. It supports an almost symmetric fundamental mode with propagation losses down to 0.5  dB/cm, the lowest losses observed so far in this class of materials. The writing process with a cascaded focus is demonstrated to be highly reliable over a large parameter range.

Following the impact of a single femtosecond light pulse on nickel nanostripes, material deformations-or "nanobumps"-are created. We have studied the dependence of these nanobumps on the length of nanostripes and verified the link with plasmons. More specifically, local electric currents can melt the nanostructures in the hotspots, where hydrodynamic processes give rise to nanobumps. This process is further confirmed by independently simulating local magnetic fields, since these are produced by the same local electric currents.

A type of a plasmonic waveguide has been proposed featuring an "open" design that is easy to manufacture, simple to excite and offers convenient access to a plasmonic mode. Optical properties of photonic bandgap (PBG) plasmonic waveguides are investigated experimentally by leakage radiation microscopy and numerically using the finite element method confirming photonic bandgap guidance in a broad spectral range. Propagation and localization characteristics of a PBG plasmonic waveguide have been discussed as a function of the wavelength of operation, waveguide core size, and the number of ridges in the periodic reflector for fundamental and higher order plasmonic modes of the waveguide.

We theoretically study the features of the surface-plasmon-polariton (SPP) excitation on single or chains of spherical metal nanoparticles located near a metal surface with an inclined incident light beam. It is found that by tuning the incident angle of an external light beam and the parameters of the surface nanoparticle structures one could obtain symmetric or asymmetric excitation of SPP beams propagating into certain directions. The reasons and conditions for this behavior and the efficiency of SPP excitation as a function of the incident angle are discussed.

Fabrication of dielectric optical components for surface plasmon polaritons (SPPs) by two-photon polymerization (2PP) is studied. This direct-write femtosecond laser technology provides a low-cost and flexible method for the fabrication and investigation of plasmonic structures and optical components. Using the 2PP technique, we fabricated narrow dielectric ridges with dimensions as small as 150 nm on metal surfaces. SPP excitation with the laser-fabricated structures and guiding along them are demonstrated.