Search

We report record-high fundamental mode output power of 8 mW at 0 °C and 1.5 mW at 100°C achieved with wafer-fused InAlGaAs-InP/AlGaAs-GaAs 1550 nm VCSELs incorporating a re-grown tunnel junction and un-doped AlGaAs/GaAs distributed Bragg reflectors. A broad wavelength tuning range of 15 nm by current variation and wavelength setting in a spectral range of 40 nm on the same VCSEL wafer are demonstrated as well. This performance positions wafer-fused VCSELs as prime candidates for many applications in low power consumption, "green" photonics.

We report coupled VCSEL arrays, emitting at 1.3 μm wavelength, in which both the optical gain/loss and refractive index distributions were defined on different vertical layers. The arrays were electrically pumped through a patterned tunnel junction, whereas the array pixels were realized by intra-cavity patterning using sub-wavelength air gaps. Stable oscillations in coupled modes were evidenced for 2x2 array structures, from threshold current up to thermal roll-over, using spectrally resolved field pattern analysis.

Coupling of L-type photonic-crystal (PhC) cavities in a geometry that follows inherent cavity field distribution is exploited for demonstrating large mode splitting of up to ~10-20 nm (~15-30 meV) near 1 µm wavelength. This is much larger than the disorder-induced cavity detuning for conventional PhC technology, which ensures reproducible coupling. Furthermore, a microlaser based on such optimally coupled PhC cavities and incorporating quantum wire gain medium is demonstrated, with potential applications in fast switching and modulation.

A transition from discrete optical modes to 1D photonic bands is experimentally observed and numerically studied in planar photonic-crystal (PhC) L(N) microcavities of length N. For increasing N the confined modes progressively acquire a well-defined momentum, eventually reconstructing the band dispersion of the corresponding waveguide. Furthermore, photon localization due to disorder is observed experimentally in the membrane PhCs using spatially resolved photoluminescence spectroscopy. Implications on single-photon sources and transfer lines based on quasi-1D PhC structures are discussed.

Site-controlled quantum-wire photonic-crystal microcavity laser is experimentally demonstrated using optical pumping. The single-mode lasing and threshold are established based on the transient laser response, linewidth narrowing, and the details of the non-linear power input-output characteristics. Average-power threshold as low as approximately 240 nW (absorbed power) and spontaneous emission coupling coefficient beta approximately 0.3 are derived.

10-Gb/s modulation speed and transmission over 10-km SM fiber with BER < 10(-11) up to 100 degrees C temperature are achieved with optimized wafer-fused GaAs/AlGaAs-InP/InAlGaAs VCSELs incorporating re-grown tunnel junction. These VCSELs operate in the 1310-nm waveband and emit more than 1-mW single mode power in the full temperature range.

We report the fabrication and the performance of phase-locked VCSEL arrays emitting near 1310 nm wavelength. The arrays were fabricated using double wafer fusion by patterning a tunnel junction layer, which serves to define the individual single mode array elements. Phase-locking in both one-dimensional and two-dimensional array configurations was confirmed by means of far field and spectral measurements as well as theoretical modeling. CW output powers of more than 12 mW were achieved.

Coupling between photonic-crystal defect microcavities is observed to result in a splitting not only of the mode wavelength but also of the modal loss. It is discussed that the characteristics of the loss splitting may have an important impact on the optical energy transfer between the coupled resonators. The loss splitting--given by the imaginary part of the coupling strength--is found to arise from the difference in diffractive out-of-plane radiation losses of the symmetric and the antisymmetric modes of the coupled system. An approach to control the splitting via coupling barrier engineering is presented.