Search

We report size-based sorting of micro- and sub-micron particles using optical forces on a planar optofluidic chip. Two different combinations of fluid flow and optical beam directions in liquid-core waveguides are demonstrated. These methods allow for tunability of size selection and sorting with efficiencies as high as 100%. Very good agreement between experimental results and calculated particle trajectories in the presence of flow and optical forces is found.

Optofluidic platforms used for biomolecular detection require spectral filtering for distinguishing analyte signals from unwanted background. Towards a fully integrated platform, an on-chip filter is required. Selective deposition of dielectric thin films on an optofluidic sensor based on antiresonant reflecting optical waveguide (ARROW) technology provides the means for localized, on-chip optical filtering. We present a lift-off technique, compatible with thin-film processing including plasma-enhanced chemical vapor and sputtering deposition. The resulting optofluidic notch filters exhibited a 20 dB rejection with linewidths as low as 20 nm for approximately 1 cm long chips consisting of liquid-core and solid-core waveguides.

A new waveguide design for an optofluidic chip is presented. It mitigates multi-mode behavior in solid and liquid-core waveguides by increasing fundamental mode coupling to 82% and 95%, respectively. Additionally, we demonstrate a six-fold improvement in lateral confinement of optically guided dielectric microparticles and double the detection efficiency of fluorescent particles.

Optical sensing platforms based on anti-resonant reflecting optical waveguides (ARROWs) with hollow cores have been used for bioanalysis and atomic spectroscopy. These integrated platforms require that hollow waveguides interface with standard solid waveguides on the substrate to couple light into and out of test media. Previous designs required light at these interfaces to pass through the anti-resonant layers.We present a new ARROW design which coats the top and sides of the hollow core with only SiO2, allowing for high interface transmission between solid and hollow waveguides. The improvement in interface transmission with this design is demonstrated experimentally and increases from 35% to 79%. Given these parameters, higher optical throughputs are possible using single SiO2 coatings when hollow waveguides are shorter than 5.8 mm., ((c) 2008 Optical Society of America)