Search

The paper presents experimental studies of a shielding plasma layer formation in front of a tungsten surface exposed with hydrogen plasma in the QSPA-M test-bed facility under the conditions of additional seeding of argon (Ar) along the target surface into the zone of plasma-surface interaction. A pulsed gas injector on the base of a fast electromagnetic valve has been developed for the local injection of Ar. The injector is capable of generating a homogeneous argon gas flow with a maximum concentration above n _Ar = 6 × 10 ^23 m ^−3 and a pulse duration of 0.5 ms. It is shown that the increase in the argon gas density in front of the surface leads to an essential decrease (in 1.5–2 times) in the energy load delivered to the target surface. In the presence of a strong magnetic field (up to 1 T), both the thickness of the shielding layer and the fraction of energy dissipated by the shield increase further. Even for moderate energy densities of the QSPA plasma streams in the experiments with Ar gas injection, less than 40% of the impacting plasma load is absorbed by the tungsten surface. The results demonstrate that this additional shielding attributed to the formation of a dense Ar plasma layer in front of the exposed W surface would be favourable for the divertor armour performance, causing the decreasing erosion of plasma-facing components in the course of transient events in a fusion reactor.

The features of plasma energy transfer to material surfaces during plasma–surface interactions (PSIs) in the presence of a strong magnetic field are investigated within the recently developed quasi-stationary plasma accelerator, QSPA-M. This novel PSI test-bed facility can reproduce edge localized mode (ELM) impacts, both in terms of heat load and particle flux to the surface, and provide plasma transportation in an external magnetic field, which mimics the divertor conditions. Investigations of energy transfer to the material surface have been performed for varied plasma heat load and external magnetic field values. Calorimetry, optical emission spectroscopy and high-speed imaging were applied for PSI characterization. For perpendicular plasma incidence, it has been shown that the transient plasma layer is formed in front of the surface by the stopped head of the plasma stream even for rather small plasma heat loads, which do not result in surface melting. The plasma density in this near-surface layer is much higher than in the impacting stream. It leads to the arisen screening effect for energy transfer to the surface. For B  =  0, the thickness of the screening layer is less than 3 cm, but it increases to 15 cm when B  =  0.8 T. The shielding effect due to the formation of a dense plasma layer in front of the exposed surface should be favorable for material performance, being important for decreasing the overall erosion of plasma-facing components during a large number of repetitive ELMs. [ABSTRACT FROM AUTHOR]

In this report a concept of a new generation QSPA with external B-field up to 2 T has been discussed. A novel test-bed facility, which was recently constructed in Kharkov IPP NSC KIPT, has been described. It allows for a new level of plasma stream parameters and its wide variation in new QSPA-M device, as well as possible combination of steady-state and pulsed plasma loads to the materials during the exposures. First plasma is recently obtained. Careful optimization of the operational regimes of the plasma accelerator’s functional components and plasma dynamics in the magnetic system of QSPA-M device has started approaching step by step the necessary level of plasma parameters and their effective variation. The relevant results on plasma stream characterization are presented. Energy density distributions in plasma stream have been measured with calorimetry. Spectroscopy and probe technique have also been applied for plasma parameters measurements. The obtained results demonstrate the ability of QSPA-M to reproduce the ELM impacts in fusion reactor, both in terms of heat load and particle flux to the surface. [ABSTRACT FROM AUTHOR]