Search

Global technological advancements drive daily energy consumption, generating additional carbon-induced climate challenges. Modifying process parameters, optimizing design, and employing high-performance working fluids are among the techniques offered by researchers for improving the thermal efficiency of heating and cooling systems. This study investigates the heat transfer enhancement of hybrid “Al2O3-Cu/water” nanofluids flowing in a two-dimensional channel with semicircle ribs. The novelty of this research is in employing semicircle ribs combined with hybrid nanofluids in turbulent flow regimes. A computer modeling approach using a finite volume approach with k-ω shear stress transport turbulence model was used in these simulations. Six cases with varying rib step heights and pitch gaps, with Re numbers ranging from 10,000 to 25,000, were explored for various volume concentrations of hybrid nanofluids Al2O3-Cu/water (0.33%, 0.75%, 1%, and 2%). The simulation results showed that the presence of ribs enhanced the heat transfer in the passage. The Nusselt number increased when the solid volume fraction of “Al2O3-Cu/water” hybrid nanofluids and the Re number increased. The Nu number reached its maximum value at a 2 percent solid volume fraction for a Reynolds number of 25,000. The local pressure coefficient also improved as the Re number and volume concentration of “Al2O3-Cu/water” hybrid nanofluids increased. The creation of recirculation zones after and before each rib was observed in the velocity and temperature contours. A higher number of ribs was also shown to result in a larger number of recirculation zones, increasing the thermal performance.

This study aims to study the discharging process to verify the influence of geometry modifications and heat transfer flow (HTF) patterns on the performance of a vertical triplex-tube latent heat container. The phase change material (PCM) is included in the middle tube, where the geometry is modified using single or multi-internal frustum tubes instead of straight tubes to enhance the discharging rate. The effects of the HTF flow direction, which is considered by the gravity and opposite-gravity directions, are also examined in four different cases. For the optimal geometry, three scenarios are proposed, i.e., employing a frustum tube for the middle tube, for the inner tube, and at last for both the inner and middle tubes. The effects of various gap widths in the modified geometries are investigated. The results show the advantages of using frustum tubes in increasing the discharging rate and reducing the solidification time compared with that of the straight tube unit due to the higher natural convection effect by proper utilization of frustum tubes. The study of the HTF pattern shows that where the HTF direction in both the inner and outer tubes are in the gravity direction, the maximum discharging rate can be achieved. For the best configuration, the discharge time is reduced negligibly compared with that for the system with straight tubes which depends on the dimensions of the PCM domain.