Search

Using a two-end bonded ZnO piezoelectric-fine-wire (PFW) (nanowire, microwire) on a flexible polymer substrate, the strain-induced change in I-V transport characteristic from symmetric to diode-type has been observed. This phenomenon is attributed to the asymmetric change in Schottky-barrier heights at both source and drain electrodes as caused by the strain-induced piezoelectric potential-drop along the PFW, which have been quantified using the thermionic emission-diffusion theory. A new piezotronic switch device with an "on" and "off" ratio of approximately 120 has been demonstrated. This work demonstrates a novel approach for fabricating diodes and switches that rely on a strain governed piezoelectric-semiconductor coupling process.

We demonstrate a mechanical-electrical trigger using a ZnO piezoelectric fine-wire (PFW) (microwire, nanowire). Once subjected to mechanical impact, a bent PFW creates a voltage drop across its width, with the tensile and compressive surfaces showing positive and negative voltages, respectively. The voltage and current created by the piezoelectric effect could trigger an external electronic system, thus, the impact force/pressure can be detected. The response time of the trigger/sensor is approximately 10 ms. The piezoelectric potential across the PFW has a lifetime of approximately 100 s, which is long enough for effectively "gating" the transport current along the wire; thus a piezoelectric field effect transistor is possible based on the piezotronic effect.

We report an external force triggered field-effect transistor based on a free-standing piezoelectric fine wire (PFW). The device consists of an Ag source electrode and an Au drain electrode at two ends of a ZnO PFW, which were separated by an insulating polydimethylsiloxane (PDMS) thin layer. The working principle of the sensor is proposed based on the piezoelectric potential gating effect. Once subjected to a mechanical impact, the bent ZnO PFW cantilever creates a piezoelectric potential distribution across it width at its root and simultaneously produces a local reverse depletion layer with much higher donor concentration than normal, which can dramatically change the current flowing from the source electrode to drain electrode when the device is under a fixed voltage bias. Due to the free-standing structure of the sensor device, it has a prompt response time less than 20 ms and quite high and stable sensitivity of 2%/microN. The effect from contact resistance has been ruled out.

Strain sensors based on individual ZnO piezoelectric fine-wires (PFWs; nanowires, microwires) have been fabricated by a simple, reliable, and cost-effective technique. The electromechanical sensor device consists of a single electrically connected PFW that is placed on the outer surface of a flexible polystyrene (PS) substrate and bonded at its two ends. The entire device is fully packaged by a polydimethylsiloxane (PDMS) thin layer. The PFW has Schottky contacts at its two ends but with distinctly different barrier heights. The I- V characteristic is highly sensitive to strain mainly due to the change in Schottky barrier height (SBH), which scales linear with strain. The change in SBH is suggested owing to the strain induced band structure change and piezoelectric effect. The experimental data can be well-described by the thermionic emission-diffusion model. A gauge factor of as high as 1250 has been demonstrated, which is 25% higher than the best gauge factor demonstrated for carbon nanotubes. The strain sensor developed here has applications in strain and stress measurements in cell biology, biomedical sciences, MEMS devices, structure monitoring, and more.