Search

Wind sensors have always played an irreplaceable role in environmental information monitoring and are expected to operate with lower power consumption to extend service lifetime. Here, we propose a breeze wake-up anemometer (B-WA) based on a rolling-bearing triboelectric nanogenerator (RB-TENG) with extremely low static power. The B-WA consists of two RB-TENGs, a self-waking-up module (SWM), a signal processing module (SPM), and a wireless transmission unit. The two RB-TENGs are employed for system activation and wind-speed sensing. Once the ambient wind-speed exceeds 2 m/s, the wake TENG (W-TENG) and the SWM can wake up the system within 0.96 s. At the same time, the SPM starts to calculate the signal frequency from the measured TENG (M-TENG) to monitor the wind speed with a sensitivity of 9.45 Hz/(m/s). After the wind stops, the SWM can switch off the B-WA within 0.52 s to decrease the system energy loss. In quiescent on-duty mode, the operating power of the B-WA is less than 30 nW, which can greatly extend the service lifetime of the B-WA. By integrating triboelectric devices and rolling bearings, this work has realized an ultralow quiescent power and self-waked-up wireless wind-speed monitoring system, which has foreseeable applications in remote weather monitoring, IoT nodes, and so on., Competing Interests: Conflict of interestThe authors declare no competing interests., (© The Author(s) 2024.)

Triboelectric nanogenerators (TENGs) can directly harvest energy via solid-liquid interface contact electrification, making them very suitable for harvesting raindrop energy and as active rainfall sensors. This technology is promising for realizing a fully self-powered system for autonomous rainfall monitoring combined with energy harvesting/sensing. Here, we report a raindrop energy-powered autonomous rainfall monitoring and wireless transmission system (R-RMS), in which a raindrop-TENG (R-TENG) array simultaneously serves as a raindrop energy harvester and rainfall sensor. At a rainfall intensity of 71 mm/min, the R-TENG array can generate an average short-circuit current, open-circuit voltage, and maximum output power of 15 μA, 1800 V, and 325 μW, respectively. The collected energy can be adjusted to act as a stable 2.5 V direct-current source for the whole system by a power management circuit. Meanwhile, the R-TENG array acts as a rainfall sensor, in which the output signal can be monitored and the measured data are wirelessly transmitted. Under a rainfall intensity of 71 mm/min, the R-RMS can be continuously powered and autonomously transmit rainfall data once every 4 min. This work has paved the way for raindrop energy-powered wireless hyetometers, which have exhibited broad prospects in unattended weather monitoring, field surveys, and the Internet of Things., Competing Interests: Conflict of interestThe authors declare no competing interests., (© The Author(s) 2022.)

Tribotronics, a new field that involves the coupling of triboelectricity and semiconductors, has attracted great interest in the nanoenergy and nanoelectronics domains. This paper proposes a tribotronic bipolar junction transistor (TBJT) that incorporates a bipolar junction transistor and a triboelectric nanogenerator (TENG) in the single-electrode mode. When the mobile triboelectric layer slides on the device surface for electrification, a bias voltage is created and applied to the emitter junction, and then the base current from the TENG is amplified. Based on the fabricated TBJT, a mechanical frequency monitoring sensor with high sensitivity and excellent stability and a finger-triggered touch switch were developed. This work demonstrated for the first time a tribotronic device with simultaneously controlled voltage and current voltage/current simultaneously controlled tribotronic device, which has promising potential applications in micro/nano-sensors, human-machine interactions, intelligent instrumentation, wearable electronics, and other applications., Competing Interests: The authors declare that they have no conflict of interest.