Search

Friction stir welding (FSW) has been considered ideal for aluminum alloy structures. The performance of FSW joints under unidirectional stress state has been widely tested, but there is still a lack of experimental data under a biaxial stress state. For accurate characterization of the mechanical properties of 2219 aluminum alloy FSW joints under a biaxial stress state, this article conducted biaxial tests. The FSW joint was tested using scanning electron microscopy (SEM) to obtain its microscopic properties and obtain the partition results of the welded joint. The stress–strain relationship and yield characteristics of welded joints under different loading ratios were studied using biaxial tensile tests of cruciform specimens combined with digital image correlation technology. By comparing it with the existing yield criteria, the yield criterion suitable for FSW joints of 2219 aluminum alloy under a biaxial tensile load was determined.

TC4 alloy is widely used in dental implantation due to its excellent biocompatibility and low density. However, it is necessary to further improve the corrosion resistance and surface hardness of the titanium alloy to prevent surface damage that could result in the release of metal ions into the oral cavity, potentially affecting oral health. In this study, Ti-N-O layers were fabricated on the surface of TC4 alloy using a two-step hollow cathode plasma source oxynitriding technique. This resulted in the formation of TiN, Ti2N, TiO2, and nitrogen-stabilized α(N)-Ti phases on the TC4 alloy, forming a Ti-N-O modified layer. The microhardness of the samples treated with plasma oxynitriding (PNO) was found to be 300–400% higher than that of untreated (UN) samples. The experimental conditions were set at 520 °C, and the corrosion current density of the PNO sample was measured to be 7.65 × 10−8 A/cm2, which is two orders of magnitude lower than that of the UN sample. This indicates that the PNO-treated TC4 alloy exhibited significantly improved corrosion resistance in the artificial saliva solutions.

CrFeCoNi and CrMnFeCoNi coatings were prepared by laser remelting method. The grain boundary characteristics distribution of both coatings was investigated by electron backscattered diffraction technique. The results showed that the CrFeCoNi coating exhibited higher fraction of low angle grain boundaries and Σ3 boundaries compared to the CrMnFeCoNi coating. The corrosion properties of the CrFeCoNi and CrMnFeCoNi coatings in 3.5 wt% NaCl solution were identified by electrochemical method and localized electrochemical impedance spectroscopy technique. The results indicated that the CrFeCoNi coating had a higher corrosion resistance than the CrMnFeCoNi coating. The better corrosion resistance of the CrFeCoNi coating could be attributed to the high fraction of Σ3 boundaries and low fraction of the high angle boundaries.

The CrFeCoNi coating was fabricated by the laser remelting method. The microstructure of the coating was detected. The corrosion behavior of coating at different temperatures was investigated by electrochemical measurements. Potentiodynamic polarization test results indicated that the corrosion current density increased with the increase in corrosion solution temperature in 3.5 wt% NaCl and 0.5 mol/L H2SO4 solutions, suggesting that the CrFeCoNi coating exhibited higher resistance to corrosion attack at lower solution temperature. The breakdown potential of the CrFeCoNi coating exhibited a decreasing trend with increasing solution temperature in 3.5 wt% NaCl solution. This indicated that the passive film formed at low temperatures had higher stability. The electrochemical impedance spectroscopy test indicated that the CrFeCoNi coating possessed higher charge transfer resistance at lower solution temperatures. The corrosion mechanisms of the coating at different temperatures were also revealed.