Search

Nanostructured Al-3.0Fe-0.42Cu-0.37Mn powder alloy was deformed by extrusion over a temperature range of 375 °C to 425 °C, a ram speed range of 1 to 30 mm/s, and an extrusion rate of 10:1. Flow stresses and strain rates were calculated from the experimental ram pressures and speeds. The stress–strain-rate–temperature relationship in the extrusion of the nanostructured alloy was found to be similar to that in hot-worked conventional materials. The extrusion, torsion, compression, and creep data of nanostructured and conventional materials, extending over ten orders of magnitude of strain rate and over two orders of magnitude of stress, were correlated by a hyperbolic-sine constitutive equation, because the power and exponential laws lose linearity at high and low stresses, respectively. The hyperbolic-sine equation is widely used to correlate the hot-working behavior of conventional materials. It was concluded that the hot working of nanostructured powders is a thermally activated process in which the rate-controlling mechanism is the climb of edge dislocations. Microstructural changes in the consolidated alloys as a function of the extrusion conditions were investigated. An analysis was made of the dislocation behavior in very small grains of nanostructured metal by transmission electron microscopy (TEM) and we identified a dislocation structure and the different ways it appears in 40- to 100-nm Al-alloy grains. We also discuss the thermally activated propagation of dislocations and their interactions with shear bands/grain boundaries (SBs/GBs), and dislocation loops. Microstructural features including low-angle GBs, high-angle GBs, and equilibrium GBs and subgrain boundaries were observed. Dislocation structures under a deformation condition were studied to investigate the microstructural evolutions, which revealed some unique microstructural features such as dislocation tangle zones (DTZs) and dense-dislocation walls (DDWs), and the recovery process is discussed herein.

Two nanostructured aluminum powder alloys (supersaturated Al4.5Cu prepared by mechanical alloying, and Al3.0Fe0.42Cu0.37Mn rich in precipitates and prepared by rapid solidification via gas atomization) were consolidated into bulk material under various processing conditions via hot extrusion. The microstructural modifications and mechanical properties of the consolidated alloys as a function of the extrusion conditions were investigated and are discussed here. The effect of pre-existing precipitates from nonsupersaturated alloy is shown to be more effective for controlling grain growth during consolidation. The increase in the extrusion load, with a concomitant increase in the extrusion rate and decrease in temperature, is shown to lead to microstructural modifications. The differences in mechanical properties measured by compressive tests are also discussed in association with the extrusion parameters. Furthermore, suggestions are given for rationalizing the extrusion rate and temperature for the consolidation of nanostructured aluminum powder alloys via hot extrusion.