Search

In the field of ultrasonic-assisted micro-forming, in addition to acoustic softening, impact effects also play a significant role, especially in terms of influencing the deformation behavior of surfaces, such as by generating more deformation on surface asperity. In this study, to understand the mechanisms involved in the effect of an impact, ultrasonic-assisted micro-forging tests were conducted on commercially pure copper, pure aluminum, and pure titanium. A method that can measure the increment in the temperature during ultrasonic vibration was developed. As a result, changes in the surface temperature of the material under the impact effect and acoustic softening were measured. It is indicated that, during ultrasonic vibration, the heat generated through acoustic softening is very limited and the main heat increase occurs after the impact effect. Once the impact effect occurs, the surface temperature increases with increasing amplitude. Nevertheless, for materials with different crystal structures, the influences of the impact effect are also different. The surfaces of copper and aluminum soften, creating more surface deformation, but the exact opposite effect is seen on a titanium surface. Observing the evolution of the microstructure on the material surface with EBSD demonstrates that the impact effect on FCC materials can reach deeper below the surface in terms of temperature diffusion compared to titanium. Meanwhile, the impact effect in the case of titanium causes the regeneration of twinning, which is reduced under the influence of the acoustic softening effect, consequently resulting in strain hardening. [ABSTRACT FROM AUTHOR]

Metallic bipolar plates (BPPs) are key components in the proton-exchange membrane fuel cell (PEMFC), which can replace traditional fossil fuels as a kind of clean energy. However, these kinds of plates, characterized by micro-channels with a high ratio between depth and width, are difficult to fabricate with an ultra-thin metallic sheet. Then, ultrasonic-vibration-assisted stamping is performed considering the acoustic softening effect. Additionally, the influence of various vibration parameters on the forming quality is analyzed. The experimental results show that ultrasonic vibration can obviously increase the channel depth. Among the vibration parameters, the vibration power has the maximum influence on the depth, the vibration interval time is the second, and the vibration duration time is the last. In addition, the rolling direction will affect the channel depth. When the micro-channels are parallel to the rolling direction, the depth of a micro-channel is the largest. This means that the developed ultrasonic-vibration-assisted stamping process is helpful for improving the forming limitation of micro-channels used for the bipolar plates in PEMFC. [ABSTRACT FROM AUTHOR]