Search

Dry hydrated lime is an air binder often used in architectural injection grouts. This study compared the influences of three commercially available dry hydrated limes on the injection grouts’ workability and mechanical properties. The main differences between the limes were in their chemical and mineralogical composition and Blaine specific surface area. The grouts were composed of dry hydrated lime, finely ground limestone filler, water, and super plasticiser. Subsequent results obtained revealed that the Blaine specific surface area is not directly related to the fresh grout properties. Grain size distribution and shape of lime particles and their aggregates in the water suspension are key parameters influencing the following fresh grout properties: fluidity, injectability, the mixture’s stability, and water retention capacity. However, the lime injection grouts’ mechanical strengths were higher in relation to an increase in the content of portlandite and the Blaine specific surface area of the dry hydrate.

Microstructure development of concrete, mortar, and paste scale of cement-based material (CBM) during the early hydration stage has a significant impact on CBM’s physical, mechanical, and durability characteristics at the high maturity state. The research was carried out using compositions with increased autogenous shrinkage and extended early age period, proposed within the RRT+ programme of the COST Action TU1404. The electrical conductivity method, used to follow the solidification process of CBM, is capable of determining the initial and final setting time, and the end of the solidification process acceleration stage for the paste and mortar scale. Simultaneous ultrasonic P- and S-wave transmission measurements revealed that the ratio of velocities VP/VS is highly dependent on the presence of aggregates—it is considerably higher for the paste scale compared to the mortar and concrete scale. The deviation from the otherwise roughly constant ratio VP/VS for each scale may indicate cracks in the material. The non-linear correlation between the dynamic and static elastic moduli valid over the three scales was confirmed. Additionally, it was found that the static E-modulus correlates very well with the square of the VS and that the VS is highly correlated to the cube compressive strength—but a separate trendline exists for each CBM scale.

Injection-grout density is an important parameter when its additional weight leads to consolidated decorative plasters becoming damaged. This is especially evident in larger detached areas. In this study, thin-walled soda&ndash, lime&ndash, borosilicate glass microspheres were used as a density-reducing constituent in hydrated lime grout mixtures. The normal density grout composition&mdash, one volume part hydrated lime and three volume parts inert limestone filler with 0.5% of the polycarboxylate ether-based superplasticiser&mdash, was modified with partial substitution of the limestone filler with lightweight glass microspheres. The following volumetric proportions between limestone filler and glass microspheres were used: 100%:0%, 67%:33%, 50%:50%, 33%:67%, and 0%:100%. With the increase of the glass microspheres&rsquo, volume, the density of the grout is gradually reduced. Furthermore, there is a decrease in the stability and injectability of fresh grout. In its hardened state, the grout&rsquo, s strength again reduces gradually, but there is no significant change in the grout&rsquo, s water absorption and water-vapour resistance. The resistance of the grout to freezing&ndash, thawing and heating&ndash, cooling cycles using distilled water or salt solution is highly improved when the microspheres are present.