Search

This preliminary study aims to evaluate the efficacy of an autologous dentin graft in preventing periodontal defects after impacted or semi-impacted lower third molars’ (M3) surgical extraction. For this purpose, radiographic and periodontal evaluation of post-extractive sockets were performed. Ten patients were enrolled in the study: twenty M3 extraction sockets were treated with a split-mouth modality. After tooth extraction, the experimental sites were filled with autologous dentin graft obtained by the extracted M3, while the control sites were filled with blood clot alone. Flaps were closed by first intention to ensure the stability of the wounds. Post-extractive sites were monitored at days 15, 90 and 180. The healing was not affected by any complications associated with the use of the autologous dentine graft in all cases. The measurements recorded at six months showed a reduction of the probing pocket depth distal to the second lower molar (M2) at both surgical sites, with a greater reduction observed at the experimental sites. Radiographic evaluation also showed a greater amount of bone gain at the grafted sites compared to the control sites. The results of this preliminary study suggest that autologous dentin grafts can be useful in preventing the formation of periodontal defects distal to M2 after M3 surgical extraction.

Piezoelectric devices are widely used in oral surgical procedures, including implant site preparation. However, little is known about the influence of working movement on temperature elevation in bone. The aim of this study was to assess the effects of two different working cycles on temperature elevation during piezoelectric implant site preparation. Sixty osteotomies at a depth of 10 mm were performed on bone blocks of bovine ribs using a piezoelectric tip with external irrigation (IM1s, Mectron Medical Technology, Carasco, Italy). A mechanical positioning device was used to guarantee reproducible working and measuring conditions. Two different working cycles, of 4 and 6 s, respectively, were tested, including both longitudinal and rotational movements. Temperature was recorded in real time with a fiber optic thermometer and applied pressure was maintained under 150 g. For each test, the highest recorded temperature (Tmax) and the mean temperature recorded from 30 s before to 30 s after the highest recorded temperature (T±30) were extrapolated. Tests duration was also recorded. Both Tmax and T±30 were significantly higher in the ‘6 s cycles’ group than the ‘4 s cycles’ group (42.44 ± 7.3 °C vs. 37.24 ± 4.6 °C, p = 0.002; 37.24 ± 4.6 °C vs. 33.30 ± 3.3 °C, p = 0.003). Test duration was also significantly higher using 6 s cycles compared to 4 s cycles (143.17 ± 29.4 s vs. 119.80 ± 36.4 s, p = 0.002). The results of this study indicate that working cycles of 4 s effectively reduce heat generation and working time during piezoelectric implant site preparation.