Search

It is known that experiments with intensive dynamic influences and high-speed deformation of specimens under tension are important in the analysis of deformations and strength of structures and their elements. The most reasonable and widely used method for obtaining dynamic stressstrain curves, characteristics of ultimate strength and deformations is the modified Kolsky method. It should be noted a small number of publications on the analysis of the influence of fillets and the length of the working part of the specimen on the most important mechanical characteristics obtained by this method. This work is aimed at increasing knowledge in this area. By numerical and experimental analysis it was established that when the working part of the specimen has a length of 5 mm, then the uniformity and one-dimensionality of the stressed state are seriously violated. When choosing the length of the specimen in the Kolsky method, there are important limitations: the length of the specimen must be much smaller than the length of the loading pulse. Therefore, in this study, two specimen lengths of 10 and 15 mm were analyzed. In this paper, we give experimental and calculated diagrams and their comparison with each other. It was shown, that for the above-mentioned lengths, the homogeneity and one-dimensionality of the stressed state is substantially improved.

A description of experimental complexes, methodological and hardware means for determining the mechanical properties of materials under high-speed deformation and fracture is given in the report. Determination of mechanical properties in the strain rate range 5•102÷103 s-1 is the first direction of work in the laboratory of “Dynamic Materials Testing”. These tests are done using automated complexes based on the Kolsky method and its modifications for compression, tension and shearing. It is also possible to determine the fracture toughness, the characteristics of dynamic crack resistance, as well as to obtain stressstrain curves of low-density materials under uniaxial strain. Original gas guns with a caliber of 10, 20 and 57 mm are used for creation a dynamic load. The study of the behavior of materials at strain rates of 105 s-1 and higher is the second direction of work. In this case, the methods of a planewave shock experiment based on gas guns of 57 and 85 mm caliber are used. Manganine and dielectric pressure sensors, as well as laser interferometry are used for measuring the parameters of elastoplastic waves and for determining such important characteristics as impact compressibility, Hugoniot yield strength, spall strength.