Search

AbstractDamping plays a crucial role in the design of offshore wind turbine (OWT) monopile foundations. The soil damping of the monopile-soil system (MSS) represents the energy dissipation mechanism arising from the interaction between the pile and the soil. It is typically derived by back-calculating from the overall damping measured in the entire OWT structure. However, few studies have independently examined the soil damping in MSS, and the impact of key parameters such as pile diameter, pile embedded depth, cyclic load amplitude, and load eccentricity on the variation of soil damping in MSS remains unclear. This paper introduces an elastoplastic-damage constitutive model for the numerical simulation of the damping ratio variation in seabed soil and MSS. The model is implemented in ABAQUS software and validated against cyclic triaxial tests on stiff clay soil. On this basis, a three-dimensional finite element sensitivity study was conducted to elucidate the effect of these key parameters on the MSS damping ratio. The results of the study reveal that the MSS damping ratio exhibits a nonlinear and asymmetric trend as the loading cycles increase. The MSS damping ratio decreases with increasing pile diameter and embedded depth but increases with increasing lateral cyclic load amplitude and load eccentricity from the mudline. [ABSTRACT FROM AUTHOR]

Suction bucket installation in pure clay or pure sand is well established. However, in layered soils, particularly in sand over clay soils, the soil plug uplift is considered a major installation risk and feasibility of installation is often questioned. In this paper, the experience from installation of two suction bucket jackets at two offshore wind farms in layered soils is reported. The installation at both sites was successful and no excess plug uplift was observed. The transfer of suction to the clay-sand interface is believed to have contributed to the success of the installations. The two cases presented in this paper provides confidence in suction bucket foundation installation in similar soil conditions. [ABSTRACT FROM AUTHOR]

This article presents the performance of the short-term bearing capacity on soft clay soil treated by Kenaf geotextile under vertical loading via a small-scale modelling test at unit gravity. The ground model was formulated by consolidating kaolin in a rigid testing compartment. In the loading test, the strip footing was represented by a rigid footing. For the treated case, a series of tests were performed to examine the effects of the burial depth of the Kenaf geotextile on the bearing capacity of the soft soil. The Kenaf geotextile was laid beneath the rigid footing (at the ground surface) and at 50, 75 and 100 mm depth from the soil surface. All the measured results of the Kenaf geotextile treated ground were compared with the untreated ground. The incorporation of Kenaf fibre geotextile was observed to enhance the bearing capacity of soft cohesive clay up to 281% depending upon the depth of the installed geotextile. The geotextile at the surface provided the highest bearing capacity and sustained the highest displacement at failure. The outcome of this research will promote the use of natural fibre geotextiles as sustainable earth reinforcement in temporary earthwork applications. [ABSTRACT FROM AUTHOR]

This study established a Couple Eulerian–Lagrange model to simulate monopile vibratory penetration for the investigation of soil plugging effect during high-frequency penetration of monopiles for wind turbine. Simulation analysis is focused particularly on soil plugging effect of a large diameter monopile during vibratory penetration into sand, clay, or layered soil. The results of the numerical simulation show that soil plugging effect is unlikely to occur during monopile penetration into the clay soil, while partial soil plugging may occur during the sand penetration. Penetration resistance at the pile toe is transferred to the radial stress around the pile wall. At a critical point penetration process, internal shaft friction becomes larger than external shaft friction. Moreover, radial pressure factors increase during partial soil plugging effect. For layered soil, the topsoil not only has great influence on the soil plugging effect, but also affects shaft friction in the subsoil during monopile penetration. [ABSTRACT FROM AUTHOR]

The present study examines the suction characteristics and swelling behavior of clayey soils when exposed to natural seawater with respect to distilled water. The effects of saline waters on the engineering behavior of soils need to be determined since the salinity of the pore fluid of soils near coastal areas increases continuously. Six clayey soil samples with different mineralogy and characteristics were gathered and tested to determine the suction and swelling characteristics in the presence of natural seawater and distilled water. The results show that the total suction values of the samples are higher in the presence of seawater than in distilled water. The samples with high swelling potential have lower matric suction values than nonswelling soils. Moreover, in contrast to swelling-type soils, the matric suction values of the nonswelling soils remain similar in the presence both distilled water and seawater. The modified free swell index (MFSI) of the samples is well correlated with the liquid limit (LL), plasticity index (PI), and cation exchange capacity (CEC) in distilled water. However, coefficients of determination decreased in the presence of seawater. Also, there is no significant correlation existing between total and matric suction values and the MFSI values of the samples. [ABSTRACT FROM AUTHOR]