Search

Background: The study aimed to observe molecular signaling, including reactive oxygen species (ROS) and mitochondrial membrane potential (ΔΨm), to evaluate the alteration of gene expression by low-level laser therapy (LLLT) and the correlation between its mechanisms and the NF-kB pathway in cells involved in orthodontic tooth movement. Methods: Osteoblast-like cells (MG63), immortalized periodontal ligament cells (iPDL), and M1 macrophage-like cells were irradiated by 980-nm LLLT with energy densities of 1 and 10 J/cm2 ΔΨm and intracellular ROS were monitored using fluorescent probes. The changes of mRNA expression were assessed using reverse transcription polymerase chain reaction (RT-PCR). NF-kB inhibitor, ROS scavenger, and ΔΨm suppressor were used to analyze signals associated with the regulation of gene expression. Finally, Western blot analysis was performed to confirm NF-kB signaling after LLLT. Results: We found the increases of ΔΨm and ROS in all three cell types after LLLT, but no significant difference was observed between 1 and 10 J/cm2 LLLT. Regarding gene expression, some target genes were upregulated in MG63 6 h, 12 h, and 1 day after LLLT and in iPDL cells 12 h and 1 day after LLLT. However, no changes occurred in M1 cells. The inhibitor that significantly reduced most changes in gene expression was NF-kB inhibitor. Western blot analysis showed the increase in p-IkBα level after LLLT in iPDL and MG63, but not in M1. Conclusion: The 980-nm LLLT increased ΔΨm and ROS production in all three cell types. However, changes in gene regulation were found only in MG63 and iPDL cells, which related to the NF-kB pathway.

Background/Purpose: Newly developed temporary anchorage devices (TADs) serve a strong orthodontic anchorage to intrude molars for correction of anterior open bite (AOB). We measured cephalometric changes in skeletal open bite patients which developed subsequently to temporomandibular joint disorders with bilateral point contacts at terminal molars. Methods: We retrospectively recruited 32 patients who had been treated their TMD before orthodontic correction (overbite: −3.14 ± 1.86 mm). Partial orthodontic appliances were used to intrude posterior teeth using TADs until positive OB obtained (T1). Full fixed appliances were then used to achieve proper overjet and overbite (T2). We collected lateral cephalograms before (T0), during (T1) and after (T2) treatment, and at follow-ups (T3). Using ANOVA, we analyzed the differences among these time points to determine treatment changes and stability of orthodontic results. Results: In this group predominantly comprising young adult women, orthodontic treatment with TADs significantly reduced upper posterior dental heights (T2-T0:-1.84 ± 0.66 mm) and facilitated the retraction and uprighting upper incisors (T2-T0: −9.92 ± 1.72°), to achieve appropriate OJ (T2-T0: −3.21 ± 0.49 mm) and OB (T2-T0: 4.10 ± 0.28 mm) with p

Background/purpose: The nature of susceptibility to condylar resorption after orthognathic surgery can be different between skeletal Class II and Class III populations, which was addressed by few in the past. The aim of the present study was to use cone-beam computed tomographic (CBCT) images to investigate the displacement and morphological changes of temporomandibular joints (TMJs) in patients received orthodontic treatment combined with orthognathic surgery. Methods: Both Class III (n = 34) and Class II (n = 17) patients were compared through overall and regional superimpositions of the initial and posttreatment CBCTs. Two-sample t-test was used to identify significance between group differences. Pearson's correlation coefficient was used to address changes of TMJ and the amount of setback or advancement. Results: The axial ramal angle increased significantly in Class III group and decreased in Class II groups after orthognathic surgery (p

The aim of this study is to comprehensively analyze the potential factors affecting the failure rates of three types of mini-implants used for orthodontic anchorage. Methods: Data were collected on 727 mini-implants (miniplates, predrilled titanium miniscrews, and self-drilling stainless steel miniscrews) in 220 patients. The factors related to mini-implant failure were investigated using a Chi-square test for univariate analysis and a generalized estimating equation model for multivariate analysis. Results: The failure rate for miniplates was significantly lower than for miniscrews. All types of mini-implants, especially the self-drilling stainless steel miniscrews, showed decreased stability if the previous implantation had failed. The stability of predrilled titanium miniscrews and self-drilling stainless steel miniscrews were comparable at the first implantation. However, the failure rate of stainless steel miniscrews increased at the second implantation. The univariate analysis showed that the following variables had a significant influence on the failure rates of mini-implants: age of patient, type of mini-implant, site of implantation, and characteristics of the soft tissue around the mini-implants. The generalized estimating equation analysis revealed that mini-implants with miniscrews used in patients younger than 35 years, subjected to orthodontic loading after 30 days and implanted on the alveolar bone ridge, have a significantly higher risk of failure. Conclusion: This study revealed that once the dental surgeon becomes familiar with the procedure, the stability of orthodontic mini-implants depends on the type of mini-implant, age of the patient, implantation site, and the healing time of the mini-implant. Miniplates are a more feasible anchorage system when miniscrews fail repeatedly.

Mechanical loading plays an important role in regulating bone formation and remodeling. Relevant mechanical stretching can increase the proliferation and differentiation of osteoblastic cells in vitro. However, little is known about the effects of supraphysiological high-level mechanical stretching on the growth and cell cycle progression of osteoblastic cells. Methods: Osteoblast-like MG-63 cells were seeded onto flexible-bottomed plates and subjected to cyclic mechanical stretching (15% elongation, 0.5 Hz) for 24 and 48 hours in a Flexercell FX-4000 strain unit. Cellular activities were measured by an assay based on the reduction of the tetrazolium salt, 3-[4,5-dimethyldiazol-2-yl]-2,5-diphenyl tetra-zolium bromide (MTT). The number of viable cells was also determined by the trypan blue dye exclusion technique. Cell cycle progression was checked by flow cytometry. mRNA expressions of apoptosis- and cell cycle-related genes (Bcl2, Bax, cdc2, cdc25C, and cyclin B1) were analyzed using an RT-PCR technique. Results: The number of viable cells significantly decreased in osteoblast-like MG-63 cells subjected to cyclic mechanical stretching for 24 or 48 hours. The MTT activity of stretched cells did not change at 24 hours, whereas a significant decrease was noted at 48 hours in comparison to the unstretched controls. The flow cytometry showed that mechanical stretching induced S-phase cell cycle arrest. Furthermore, exposure to mechanical stretching led to apoptotic cell death, as shown by the increase in the hypodiploid sub-G0/G1 cell population. Furthermore, a decreased cdc25C mRNA level was consistently noted in stretched cells. However, the mRNA expressions of Bcl2, Bax, cdc2, and cyclin B1 genes were not significantly altered compared to the unstretched control cells. Conclusion: High-level mechanical stretching induced S-phase cell cycle arrest and apoptotic cell death in osteoblastic cells. The results suggest that heavy tensional force is a negative regulator of osteoblastic activities and should, therefore, be minimized if bone formation is attempted during orthodontic/orthopedic treatment.

This study aimed at comparing the transverse and sagittal angulations of proximal segment after sagittal split ramus osteotomy (SSRO) and intraoral vertical ramus osteotomy (IVRO), and examining their influences on the stability of distal segment. Methods: Patients who received SSRO (n = 21) or IVRO (n = 11) for mandibular setback were included. Lateral and posteroanterior cephalograms taken within 1 month before surgery (T1), within 1 week after surgery (T2), and at least 6 months after surgery (T3) were analyzed. The angulation of each proximal segment relative to the upper orbital margin line was measured on posteroanterior cephalogram and the sum of both angles (total ramus angle, TRA) was obtained. On lateral radiograph, ramus inclination angle (RIA) relative to a horizontal reference line 7° to the sella–nasion was assessed and B-point position was measured. Results: From T1 to T2, more increases in TRA and RIA were noted after IVRO than after SSRO. From T2 to T3, TRA and RIA significantly decreased in IVRO group but remained relatively stable in SSRO group. ΔTRAT1–T2 positively related to upward rotation of distal segment for SSRO and downward rotation for IVRO from T2 to T3. For SSRO only, ΔRIAT1–T2 significantly related to forward movement of distal segment during remodeling. Conclusion: TRA and RIA increase significantly after IVRO and then regress, whereas they increase mildly after SSRO and remain stable. Increase in TRA significantly relates to distal segment rotation during remodeling for both surgeries, but increase in RIA relates to forward relapse of the distal segment only for SSRO. The reasons underlying the correlations are not certain and deserve future investigations.

Background/Purpose: The age at menarche reflects a pubertal girl's physiologic maturity. The aims of this study were to evaluate the relationship between the age at menarche and skeletal maturation in female orthodontic patients. Methods: Hand-wrist radiographs and lateral cephalometric radiographs from 304 adolescent female subjects (age, 8–18.9 years) were selected from the files of the Department of Orthodontics, National Taiwan University Hospital (NTUH). Hand-wrist bone maturation stages were assessed using the NTUH Skeletal Maturation Index (NTUH-SMI). Cervical vertebral maturation stages (CVMS) were determined using the latest CVMS Index. Menarcheal ages were self-reported by the patients and verified by the patients' mothers. The relationships between the NTUH-SMI or CVM stages and menarcheal status were investigated. Results: More than 90% of the 148 subjects who had already attained menstruation had skeletal maturation beyond the NTUH-SMI stage four or CVMS III. However, the subjects who had never experienced menarche mostly had skeletal maturation before NTUH-SMI stage five or CVMS IV. During the period of orthodontic treatment, 19 females experienced their menarche. The mean age at menarche for the 167 female patients in total was 11.97 years. In average, menarche occurred between NTUH-SMI stages four and five or between CVM stages III and IV. The percentage of girls with menses increased from 1.2% at age 9 to 6.6% at age 10, 39.5% at age 11, 81.4% at age 12, 97% at age 13, and 100% at age 14. Compared with the results obtained 20 years previously, we found a downward shift of 0.47 years per decade for the mean age at menarche in female orthodontic patients. Conclusion: The majority of female orthodontic patients have passed the pubertal growth spurt when they experience their menarche. Menarche usually follows the pubertal growth spurt by about 1 year and occurs after NTUH-SMI stage four or CVMS III.

The skeletal maturation status of a growing patient can influence the selection of orthodontic treatment procedures. Either lateral cephalometric or hand-wrist radiography can be used to assess skeletal development. In this study, we examined the correlation between the maturation stages of cervical vertebrae and hand-wrist bones in Taiwanese individuals. Methods: The study group consisted of 330 male and 379 female subjects ranging in age from 8 to 18 years. A total of 709 hand-wrist and 709 lateral cephalometric radiographs were analyzed. Hand-wrist maturation stages were assessed using National Taiwan University Hospital Skeletal Maturation Index (NTUH-SMI). Cervical vertebral maturation stages were determined by the latest Cervical Vertebral Maturation Stage (CVMS) Index. Spearman's rank correlation was used to correlate the respective maturation stages assessed from the hand-wrist bones and the cervical vertebrae. Results: The values of Spearman's rank correlation were 0.910 for males and 0.937 for females, respectively. These data confirmed a strong and significant correlation between CVMS and NTUH-SMI systems (p < 0.001). After comparison of the mean ages of subjects in different stages of CVMS and NTU-SMI systems, we found that CVMS I corresponded to NTUH-SMI stages 1 and 2, CVMS II to NTUH-SMI stage 3, CVMS III to NTUH-SMI stage 4, CVMS IV to NTUH-SMI stage 5, CVMS V to NTUH-SMI stages 6, 7 and 8, and CVMS VI to NTUH-SMI stage 9. Conclusion: Our results indicate that cervical vertebral maturation stages can be used to replace hand-wrist bone maturation stages for evaluation of skeletal maturity in Taiwanese individuals.