Search

A comprehensive investigation of the emission characteristics for electrons induced by X-rays of a few hundred eV at grazing-incidence angles on an atomically clean Cu(111) sample during laser excitation is presented. Electron energy spectra due to intense infrared laser irradiation are investigated at the BESSY II slicing facility. Furthermore, the influence of the corresponding high degree of target excitation (high peak current of photoemission) on the properties of Auger and photoelectrons liberated by a probe X-ray beam is investigated in time-resolved pump and probe measurements. Strong electron energy shifts have been found and assigned to space-charge acceleration. The variation of the shift with laser power and electron energy is investigated and discussed on the basis of experimental as well as new theoretical results. [ABSTRACT FROM AUTHOR]

A unique analytical method is proposed for local structure analysis via extended X-ray absorption fine structure (EXAFS) spectroscopy. The measurement of electron energy distribution curves at various excitation photon energies using an electron energy analyzer is applied to determine a specific elemental Auger spectrum. To demonstrate the method, the N K-edge EXAFS spectra for a silicon nitride film were obtained via simultaneous measurement of the N KLL Auger and background spectra using dual-energy windows. The background spectrum was then used to remove the photoelectrons and secondary electron mixing in the energy distribution curves. The spectrum obtained following this subtraction procedure represents the `true' N K-edge EXAFS spectrum without the other absorptions that are observed in total electron yield N K-edge EXAFS spectra. The first nearest-neighbor distance (N-Si) derived from the extracted N K-edge EXAFS oscillation was in good agreement with the value derived from Si K-edge analysis. This result confirmed that the present method, referred to as differential electron yield (DEY)-EXAFS, is valid for deriving local surface structure information for low- Z elements. [ABSTRACT FROM AUTHOR]

Surface-sensitive analysis via extended X-ray absorption fine-structure (EXAFS) spectroscopy is demonstrated using a thickness-defined SiO2 (12.4 nm)/Si sample. The proposed method exploits the differential electron yield (DEY) method wherein Auger electrons escaping from a sample surface are detected by an electron analyzer. The DEY method removes local intensity changes in the EXAFS spectra caused by photoelectrons crossing the Auger peak during X-ray energy sweeps, enabling EXAFS analysis through Fourier transformation of wide-energy-range spectral oscillations. The Si K-edge DEY X-ray absorption near-edge structure (XANES) spectrum appears to comprise high amounts of SiO2 and low Si content, suggesting an analysis depth, as expressed using the inelastic mean free path of electrons in general electron spectroscopy, of approximately 4.2 nm. The first nearest neighbor (Si-O) distance derived from the Fourier transform of the Si K-edge DEY-EXAFS oscillation is 1.63 Å. This value is within the reported values of bulk SiO2, showing that DEY can be used to detect a surface layer of 12.4 nm thickness with an analysis depth of approximately 4.2 nm and enable `surface EXAFS' analysis using Fourier transformation. [ABSTRACT FROM AUTHOR]

Radioactive 125I emits short-range Auger electrons and represents a human health risk when incorporated in thyroglobulin of the thyroid. Quantitative evaluation of this risk can only be realised if local atomic order about iodine in the thyroid is known. Here, extended X-ray absorption fine structure (EXAFS) has been used to probe the local structure about iodine in pure thyroid hormone, thyroxine. These data are consistent with a model where iodine is bound to a single iodinated carbon ring linked to an oxygen atom, similar to a previously published model for monoiodotyrosine, a major iodinated residue in thyroglobulin. Several structural models for the local environment of iodine from rat, human and sheep have been tested and these data are found to be compatible with a slightly modified environment with respect to that found for thyroxine. The best-fit models include the following three components: (i) iodine covalently bonded to a tyrosine ring, as found for thyroxine; (ii) iodine bonded quasi-covalently to a carbonyl ligand in partially filled (50%) sites; (iii) partially filled sites (50-40%) of carbonyl ligands, with oxygen at van der Waals distances from iodine. Advantages of using Fourier-filtered EXAFS for complex crystal structures are discussed. [ABSTRACT FROM AUTHOR]