Search

A synchrotron-based technique using Compton scattering imaging is presented. This technique has been applied to a coin battery (CR2023), and the cross-sectional image has been obtained in 34 ms without sample rotation. A three-dimensional image of the whole structure has been reconstructed from 74 cross-sectional images taken consecutively by scanning the incident, wide X-ray beam along one direction. This work demonstrates that quick cross-sectional imaging of regions of interest and three-dimensional image reconstruction without sample rotation are feasible using Compton scattering imaging.

High-resolution (0.12 a.u.) electron momentum density projections (Compton profiles) of a hexagonal Zn single crystal have been measured along five high-symmetry directions in reciprocal space. The experiment was performed with the use of 115.6 keV synchrotron radiation on the BL08W station at SPring-8. The quality of the measured Compton profiles is significantly better than that of previous medium- and high-resolution data. The experimental data were compared with the corresponding theoretical Korringa-Kohn-Rostoker (KKR) and density functional theory (DFT) calculations. Some minor and major differences between the two theoretical band-structure calculations have been observed. However, the good quality experimental results indicate their better agreement with DFT.

Compton scattering is one of the most promising probes for quantitating Li under in operando conditions, since high-energy X-rays, which have high penetration power, are used as the incident beam and the Compton-scattered energy spectrum has specific line-shapes for each element. An in operando quantitation method to determine the Li composition in electrodes has been developed by using line-shape (S-parameter) analysis of the Compton-scattered energy spectrum. In this study, S-parameter analysis has been applied to a commercial coin cell Li-ion rechargeable battery and the variation of the S-parameters during the charge/discharge cycle at the positive and negative electrodes has been obtained. By using calibration curves for Li composition in the electrodes, the change in Li composition of the positive and negative electrodes has been determined using the S-parameters simultaneously.

Measurement of combustion gas by high-energy X-ray Compton scattering is reported. The intensity of Compton-scattered X-rays has shown a position dependence across the flame of the combustion gas, allowing us to estimate the temperature distribution of the combustion flame. The energy spectra of Compton-scattered X-rays have revealed a significant difference across the combustion reaction zone, which enables us to detect the combustion reaction. These results demonstrate that high-energy X-ray Compton scattering can be employed as an in situ technique to probe inside a combustion reaction.

The first results of multiple scattering simulations of polarized high-energy X-rays for Compton experiments using a new Monte Carlo program, MUSCAT, are presented. The program is developed to follow the restrictions of real experimental geometries. The new simulation algorithm uses not only well known photon splitting and interaction forcing methods but it is also upgraded with the new propagation separation method and highly vectorized. In this paper, a detailed description of the new simulation algorithm is given. The code is verified by comparison with the previous experimental and simulation results by the ESRF group and new restricted geometry experiments carried out at SPring-8.

Results of studies on Compton scattering imaging using synchrotron high-energy X-rays are reported. The technique is applied to a discharging coin cell, and the intensity of Compton scattered X-rays from the inside of the cell has been measured as a function of position and time. The position-time intensity map captures the migration of lithium ions in the positive electrode and reveals the structural change due to the volume expansion of the electrode. This experiment is a critical step in developing synchrotron-based Compton scattering imaging for electrochemical cells at a product level.

A compound refractive lens made of nickel and designed for focusing high-energy synchrotron X-rays is presented. The lens consists of 600 parabolic grooves and focuses X-rays in one plane only (planar lens). The lenses made and investigated by us earlier exhibited low transmission and irregularities in the focused beam profile. Since then, improvements in lens manufacturing technology have been made. The present lens gives an almost Gaussian profile and produces four times higher intensity at its maximum compared with the intensity of primary X-ray beams of 174 keV.

The propagation of X-rays through a compound refractive lens (CRL) with imperfect CRL elements is investigated. The trajectories of random rays within the geometrical optics regime are calculated in one plane using Monte Carlo methods. Three different lenses were simulated: Be, Al and Ni lenses designed for photon energies of 20 keV, 60 keV and 175 keV, respectively. The results show that while transverse displacements of single elements in a CRL do not influence imaging resolution, rotational errors can be important. Systematic calculations of aberrations owing to the deviation of the element's surface from a perfect parabolic shape are also presented.

This study has revealed the advantages of the use of 116 keV X-rays as an excitation source of X-ray fluorescence (XRF) analyses. This technique is suitable for nondestructive multielemental analyses of heavy elements such as rare-earth elements. The lowest MDL value evaluated for the bulk analysis of a JG-1 standard reference sample (granite rock) was 0.1 ppm for W for a 500 s measurement. The spectrum of standard glass samples of SRM612 demonstrated clearly resolved K-line peaks of more than 30 elements, including all the existing rare-earth elements, at 50 ppm levels. The calibration curve for the determination of a rare-earth element shows a linear relation between the XRF intensity and concentrations from 10 to 0.03 ng. This powerful technique should be useful for nondestructive analyses of rare-earth and heavy elements in geological, geochemical and archaeological samples as well as industrial materials.

The design and performance of a new spectrometer for coincidence measurements between the Compton scattered photon and the recoil electron are described. Coincidence measurements give direct information on the three-dimensional electron momentum density (EMD) of condensed matter. The present spectrometer measures energy spectra of both the photon and the electron. The energy spectrum of electrons is measured by a time-of-flight method using single-bunch operation at the Photon Factory Accumulator Ring (PF-AR). The energy resolution obtained for the recoil electron is 190 eV, which is better than that of the photon detector, so that a momentum resolution of the three-dimensional EMD of 0.3 atomic units can be achieved.