Search

Abstract: The surface of graphene is modified by nickel nanoparticles which are in-situ reduced from NiO nanoparticles by graphene. The nickel nanoparticles obtained are up to 10nm in size and are strongly anchored on the surface of graphene sheets. As an anode material for lithium ion batteries, the graphene–Ni hybrid material delivers a reversible capacity of 675mAhg−1 after 35 discharge/charge cycles at a current density of 100mAg−1, corresponding to 85% retention of the initial charge capacity. In addition, the graphene–Ni hybrid electrode exhibits much better rate capability compared to its pure counterpart operated at various rates between 200 and 800mAg−1. Such enhanced lithium storage performance of the graphene–Ni hybrid electrode can be ascribed to the enhanced electronic transport and Li+ migration through the solid electrolyte interphase (SEI) film as a consequence of that the anchored nickel nanoparticles increase the electronic conductivity and modify the structure of SEI film covering the surface of graphene. [Copyright &y& Elsevier]

Abstract: A hierarchically Fe2O3@Co3O4 nanowire array is prepared by the aid of hydrothermal synthesis and sacrificial hydrolysis method. The obtained nanowire array shows hierarchical porosity and large surface area. The resulted Fe2O3@Co3O4 nanowire array is evaluated as an anode material for Li ion batteries, which exhibits high capacity and good cycle stability (1005.1 mAh g−1 after 50 cycles at a current density of 200 mA g−1) and an excellent rate performance, mainly owing to the unique hierarchical nanowire architecture and an elegant synergistic effect of two electrochemically active materials. The developed strategy can be readily generalized to construct other multifunctional hybrid nanostructures, which will be promising materials for high-performance electrochemical devices. [Copyright &y& Elsevier]

Abstract: Relatively small hysteresis in voltage, appropriate electromotive force and low average delithiation voltage make MnO, among many transition metal oxides. MnO/reduced graphene oxide sheet (MnO/RGOS) hybrid is synthesized by a two-step electrode design consisting of liquid phase deposition of MnCO3 nanoparticles on the surface of graphene oxide sheets followed by heat treatment in flowing nitrogen. As an anode for Li-ion batteries, the MnO/RGOS hybrid electrode shows a reversible capacity of 665.5 mA h g−1 after 50 cycles at a current density of 100 mA g−1 and delivers 454.2 mA h g−1 at a rate of 400 mA g−1, which is obviously better than that of bare MnO electrode. Those reasons for such enhanced electrochemical properties are investigated by galvanostatic intermittent titration technique (GITT) as well as electrochemical impedance spectroscopy (EIS). The probable origins, in the term of thermodynamic and kinetic factors, for the marked hysteresis in voltage observed between charge and discharge are also discussed. [Copyright &y& Elsevier]

Abstract: Co-doped NiO nanoflake arrays with a cellular-like morphology are fabricated by low temperature chemical bath deposition. As anode material for lithium ion batteries (LIBs), the array film shows a capacity of 600mAhg−1 after 50 discharge/charge cycles at low current density of 100mAg−1, and it retains 471mAhg−1 when the current density is increased to 2Ag−1. Appropriate electrode configuration possesses some unique features, including high electrode–electrolyte contact area, direct contact between each naonflake and current collector, fast Li+ diffusion. The Co2+ partially substitutes Ni3+, resulting in an increase of holes concentration, and therefore improved p-type conductivity, which is useful to reduce charge transfer resistance during the charge/discharge process. The synergetic effect of these two parts can account for the improved electrochemical performance. [Copyright &y& Elsevier]