Search

A variety of centrifugal compressors are used in various fields of industry such as aircraft, home appliances, and vehicles. Comfort and quietness are important in these uses. As a result, noise has become an important consideration in compressor design besides the conventional performance parameters such as efficiency and pressure ratio. However, compressor noise has been difficult to understand because of the lack of information. The aim of this paper is to investigate the aero-acoustic characteristics of a centrifugal compressor for the fuelcell vehicle by experiments. The existing compressor system is modified to measure the internal pressure fluctuation at the impeller inlet, the impeller outlet and the diffuser outlet. Four microphone probes are also installed to determine the external noise levels and spectra of the compressor in an airtight room according to the RPM and mass flow rate. The test results show the possibility to tell the relative noise level of a centrifugal compressor with the internal pressure data. The external microphone signals have relation to the internal pressure signals. They have similar patterns and spectra. It is a noteworthy phenomenon because it is easier and inexpensive to predict pressure behaviors than noise characteristics of centrifugal compressors. The dominant noise source is the tonal noise during normal operation. But the broadband noise component due to the turbulent flow in the compressor increases during low flow rate operation. Computational simulations are carried out to describe these phenomena and to identify noise indicators. The turbulence kinetic energy and the pressure distribution obtained from CFD results may be indicative of the relative noise intensity of the compressor. The experimental facility, instrumentation and simulation conditions are described, and the results are presented in this paper. [ABSTRACT FROM AUTHOR]

A numerical study of casing treatments on a centrifugal compressor to improve stability and stall margin is presented. High efficiency, high pressure ratio, and a wide operating range are required for a high-performance centrifugal compressor. A ring groove casing treatment is effective for flow range enhancement in centrifugal compressors. Compressor performance was analyzed according to the ring groove location, and the results were compared with the case without a ring groove. The effect of guide vanes in the ring groove was also investigated. Four variants of grooves were modeled and simulated using computational fluid dynamics to optimize the groove location. Numerical analysis was performed using a commercial code ANSYS-CFX program. The simulation results showed that the ring groove increased the operating range of the compressor. The ring groove with guide vanes improved both performance of the compressor at low flow rates and the stall margin of the compressor. [ABSTRACT FROM AUTHOR]

Finite element (FE) analysis and experiment for weld residual stress (WRS) in the pressurizer safety nozzle mockup is described in various processes and results. Foremost of which is the dissimilar simulation metal welding (DMW) between carbon steel and austenitic stainless steel. Thermal and structural analyses were compared with actual residual stress, and actual measurements of. Magnitude and distribution of WRS in the nozzle mockup were assessed. Two measurement methods were used: hole-drilling method (HDM) with strain gauge for residual stress on the surface of the mockup, and block removal and splitting layer (BRSL) method for through-thickness. FE analysis and measurement data showed good agreement. In conclusion, the characteristics of weld residual stress of DMW could be well understood and the simplified FE analysis was verified as acceptable for estimating WRS. [ABSTRACT FROM AUTHOR]