Search

It is vital to reveal the effect of microstructure features on the corrosion behavior of pure aluminum anode in alkaline electrolyte for Al-air batteries. In this paper, we extensively studied the influence of mechanical deformation on the corrosion microstructure and then corrosion features of pure aluminum anode. The results demonstrate that the cold-rolling deformation could facilitate the grain size refinement of pure aluminum. Surprisingly, the aluminum anodes with smaller grain sizes and larger grain boundary areas could effectively improve the corrosion resistance. The further characterization of the microstructure indicates that the deformation is capable of causing the fracture of the cathodic secondary phase precipitate clusters thus weakening the galvanic corrosion effects. The results of this paper could gain insights into the design and processing of pure aluminum for Al-air battery. [ABSTRACT FROM AUTHOR]

In this paper, the deformation mechanisms of a Fe–2.25%Cr–1%Mo (P22) steel are studied after tensile tests at room temperature (RT) and 550 °C (HT), creep-fatigue tests at 550 °C and stress relaxation test at 550 °C (HTSR). The RT, HT and HTSR tests produced permanent strain of about 2.5% by different processes. Deformation features such as the orientation of the grains, local misorientation, grain boundary type and distribution, etc., were characterized using electron backscatter diffraction. Transmission electron microscopy was done subsequently to obtain greater insight into the dislocation substructures. The as-received sample had a ferritic–bainitic microstructure, and a large amount of local misorientation was found in the bainite, indicating plastic strain due to phase transformation. After tensile strain to 2.5% at room temperature, the dislocations formed very small substructures (~100–200 nm) in the ferrite grains, and most of the retained plastic strain seemed to be concentrated in the bainite after deformation. Both the ferrite and bainite showed much lower local misorientation and dislocation wall content after a tensile test to 2.5% strain at 550 °C. Compared to the RT tensile sample, after creep-fatigue at 550 °C, the substructures in ferrite opened up considerably and formed small-angle grain boundaries, with clean areas as large as 20–25 μm. After stress relaxation at 550 °C, the ferrite displayed even less substructure, while the bainite seemed to have greater amounts of local misorientation than in the creep-fatigue case. However, the degree of misorientation was less pronounced than in the room temperature tensile case. These results have been discussed with respect to the causes behind the phenomena observed herein and their possible effects on mechanical behaviour. [ABSTRACT FROM AUTHOR]

Severe plastic deformation through high-pressure torsion is used to refine the grain structure of the Mg–Al–Zn alloy down to ~ 140 nm and low temperature annealing is used to produce samples with different grain sizes, within the ultrafine range. The mechanical behavior is investigated using different testing techniques including microhardness, indentation creep, plane-strain compression, creep, and miniaturized tensile testing. The results allow a comprehensive analysis of the deformation mechanism. It is shown that the relationship between the flow stress and the inverse of the square root of the grain size is not linear in the ultrafine grained range and depends on temperature and strain rate. Grain refinement hardening and grain refinement softening can be observed at different temperatures and strain rates. There is an increase in strain-rate sensitivity and a decrease in apparent activation volume with decreasing the grain size. These experimental observations agree with the deformation mechanism of grain boundary sliding provided the thermal contribution for the threshold stress is taken into account. [ABSTRACT FROM AUTHOR]