Search

Abundant {10–12} twins appeared in an extruded Mg-2.8Y (wt. %) sheet with rare-earth (RE) texture under compression along the transverse direction (TD). Twinning-detwinning behavior during compression-tension loading was quantitatively investigated via quasi-in-situ EBSD observation. The evolution of deformation mechanisms was quantitatively studied by calculation of the plastic strain fraction of twinning, detwinning, and dislocation slip. Twinning and detwinning were the dominant deformation modes in compression and reverse tension, respectively, owing to their relatively higher Schmid factors (SF) and lowest activation stresses (τ). Twin variants with SF ranking 1st and 2nd were activated preferentially while detwinning with low SF ranking showed high activation. The impact of texture and load path on variant selection was systematically discussed. Moreover, short twin chains only passing through two or three grains caused by twinning transfer were observed. Grain boundary misorientation angle (GBMA) and geometric compatibility factor (m’) were introduced to analyze the crystallographic characteristics of twinning transfer. GBMA ≤34.5° or m’ ≥ 0.80 is a necessary condition for most twinning transfer events. RE texture as well as the nearly uniform distribution of GBMA gave rise to short twin chains and restricted the formation of long twin bands. The relationship between GBMA and m’ was also discussed.

Grain refinement could promote the activation of non-basal slip and enhance the strength and ductility of Mg alloy simultaneously. In this work, the grain size effect on deformation modes and deformation heterogeneity and its relations to crystallographic orientation in a rolled Mg–1.58Zn–0.1Ca alloy sheet with a weakened transverse direction (TD) spread texture were investigated via intragranular misorientation axis (IGMA) and high resolution-digital image correlation (HR-DIC) measurement. The results indicate that a decrease of the grain size from 55 to 13 μm increased the yield strength (YS) by 56.9%, from 72 MPa to 113 MPa, for the TD samples, but only by 8% for the rolling direction (RD) samples, from 125.7 to 135.7 MPa. Moreover, grain refinement enhanced the elongation by 76.4% for the TD samples, from 11% to 19.1%, and merely by 26.5% for the RD samples, from 16.6% to 21%. The transition in dominant deformation modes due to grain size decreasing can be summarized as: for the RD samples: basal slip → prismatic slip; for the TD samples: basal slip + tension twinning → prismatic slip. The enhanced activity of prismatic slip in the fine-grained (FG)-TD and FG-RD samples can be ascribed to the reduced ratio of critical resolved shear stress (CRSS)prismatic/CRSSbasal. For both the RD and TD samples, grain refinement facilitated deformation homogeneity, which could be related to the enhanced activity of basal slip and non-basal slip, as well as the resulting improved deformation compatibility across grain boundary.