Search

Side deep placement of nitrogen plays an important role in improving rice yield and nitrogen use efficiency. Few studies have examined the effects of reducing the times of nitrogen (RTN) application and reducing the nitrogen rate (RNR) of application on rice yield and nitrogen use efficiency under side deep placement of nitrogen in paddy fields. Therefore, a field experiment of RNT and RNR treatments was conducted with nine fertilization modes during the 2018–2019 rice growing seasons in a rice–wheat cropping system of the lower reaches of the Yangtze River, China. Rice yield and nitrogen use efficiency were investigated under side deep placement of nitrogen. We found that under the same nitrogen application rate, the yield of RTN3 increased by 9.64 and 10.18% in rice varieties NJ9108 and NJ5718, respectively, compared with the farmers’ fertilizer practices (FFP). The nitrogen accumulation of RTN3 was the highest at heading stage, at 11.30 t ha−1 across 2018 and 2019. Under the same nitrogen application rate, the N agronomic use efficiency (NAE), N physiological efficiency (NPE) and N recovery efficiency (NRE) of RTN3 were 8.1–21.28%, 8.51–41.76% and 0.28–14.52% higher than those of the other fertilization modes, respectively. RNR led to decreases in SPAD value, leaf area index (LAI), dry matter accumulation, nitrogen accumulation, and nitrogen use efficiency. These results suggest that RTN3 increased rice yield and nitrogen use efficiency under the side deep placement of nitrogen, and RNR1 could achieve the goals of saving cost and increasing resource use efficiency. Two fertilization modes RTN3 and RNR1 both could achieve the dual goals of increasing grain yield and resource use efficiency and thus are worth further application and investigation.

Mechanical transplanting has been applied to rice cultivation to save labor costs and ease labor shortages in Asian countries, especially in China. However, little information is available related to the characteristics of agronomic performance when comparing inter-sub-specific hybrid rice (IHR) and inbred japonica rice (IJR) under mechanical transplanting method. In 2013 and 2014, field experiments were conducted using IHR (Yongyou 2640) and IJR (Wuyunjing 24) under two cultivation patterns, that is, pot seedlings mechanically transplanted (PS) and carpet seedlings mechanically transplanted (CS). Grain yield, yield components, leaf area index (LAI), leaf area duration (LAD), aboveground biomass, crop growth rate (CGR), nitrogen (N) uptake, and N accumulation were investigated. When compared with CS, PS displayed significantly increased grain yield for both varieties because the larger sink size allowed higher N accumulation from panicle initiation to maturity. Moreover, total aboveground biomass under PS increased significantly compared with that under CS; that is, higher photosynthetic productivity resulted from a greater LAI and higher LAD during the grain filling stage. Higher N absorption capacity in the middle and late growth periods resulted in significantly enhanced total N uptake under PS. When compared with IJR for both treatments, IHR generated 75.2% more grain yield. However, the characteristics creating high yield of IHR were different from those of IJR. Greater aboveground biomass production as well as higher N uptake and accumulation created higher grain yield in IHR than in IJR. These results suggest higher yield could be achieved using PS with IHR, attributing to exploit both yield superiority and productive potential.

Several studies have demonstrated the effect of planting methods on rice yield, but information on the climate resources is limited. This study aims to reveal the effects of planting methods on climate resources associated with rice yield in a rice-wheat rotation system in the lower reaches of the Yangtze River, China. Field experiments were conducted in 2014 and 2015 with two japonica, two indica hybrid, and two japonica-indica hybrid varieties grown under three mechanized planting methods: carpet seedling of mechanical transplanting (CT), mechanical direct seeding (DS), and pot-hole seedling of mechanical transplanting (PT). The rice yield and total dry matter under PT were greater than those under CT and DS methods. Besides, the entire growth duration and daily production showed significant positive relations with rice yield. Compared with CT and DS, the effective accumulated temperature and cumulative solar radiation of rice under PT were higher in phenological phases. In addition, the dry matter/effective accumulated temperature and solar energy utilization of rice under CT and DS were higher during vegetative phase and lower during reproductive and grain filling phases in contrast to PT. The mean daily temperature and mean daily solar radiation in the entire growth duration showed significant positive correlation with rice yield, total dry matter, and harvest index. This study demonstrated that when the mean daily temperature is 20.1°C in grain filling phase, rice yield could be increased by selecting mechanized planting methods. Most varieties under PT method exhibited high yield and climate resources use efficiency compared with CT and DS. In conclusion, the PT method could be a better cultivation measure for high rice yield, accompanied with high temperature and solar radiation use efficiency in a rice-wheat rotation system in the lower reaches of the Yangtze River, China.

Understanding the differences in yield traits of rice among pothole seedling of mechanical transplanting (PSMT), carpet seedling of mechanical transplanting (CSMT) and mechanical direct seeding (MDS) is of great importance not only for rice scientists but also for rice farmers to develop a high-yield production system under mechanical conditions in a rice-wheat rotation system. However, such traits are yet to be studied among rice varieties of japonica-indica hybrid rice (JIHR), japonica conventional rice (JCR) and indica hybrid rice (IHR). Field experiments were conducted in 2014 and 2015, where six cultivars of the three rice types JIHR, JCR and IHR were grown individually with PSMT, CSMT and MDS methods, under respective managements for each method to achieve the maximum attainable yield. Results showed that (i) the PSMT significantly increased grain yield of JIHR by 22.0 and 7.1%, of JCR by 15.6 and 3.7% and of IHR by 22.5 and 7.4%, compared to MDS and CSMT on average across the two years, respectively. The highest yield was produced by the combination of JIHR and PSMT; (ii) high yield under PSMT was mainly attributed to large sink capacity and high-efficient dry matter accumulation. With sufficient panicles per hectare, the increase of spikelet number per panicle, especially the increase in spikelet number of the secondary rachis-branches was determined to be the optimal approach for developing a large sink capacity for rice under PSMT. The optimal tillers development, large leaf area index at heading stage, and high leaf area duration, crop growth rate and net assimilation rate during grain-filling phase could be the cause of sufficient dry matter accumulation for rice under PSMT; (iii) moreover, the PSMT favored plant growth as well as enriched the stems plus sheaths during grain-filling phase, as compared with CSMT and MDS. These results suggest that PSMT may be an alternative approach to increasing grain yield in a rice-wheat rotation system in the lower reaches of the Yangtze River in China.

Although studies on the balance between yield and quality of japonica soft super rice are limited, they are crucial for super rice cultivation. In order to investigate the effects of nitrogen application rate on grain yield and rice quality, two japonica soft super rice varieties, Nanjing 9108 (NJ 9108) and Nanjing 5055 (NJ 5055), were used under seven N levels with the application rates of 0, 150, 187.5, 225, 262.5, 300, and 337.5 kg ha−1. With the increasing nitrogen application level, grain yield of both varieties first increased and then decreased. The highest yield was obtained at 300 kg ha−1. The milling quality and protein content increased, while the appearance quality, amylose content, gel consistency, cooking/eating quality, and rice flour viscosity decreased. Milling was significantly negatively related with the eating/cooking quality whereas the appearance was significantly positively related with cooking/eating quality. These results suggest that nitrogen level significantly affects the yield and rice quality of japonica soft super rice. We conclude that the suitable nitrogen application rate for japonica soft super rice, NJ 9108 and NJ 5055, is 270 kg ha−1, under which they obtain high yield as well as superior eating/cooking quality.

Understanding the morphological and physiological traits associated with improved filling efficiency in large-panicle rice varieties is critical to devise strategies for breeding programs and cultivation management practices. Information on such traits, however, remains limited. Two large-panicle varieties with high filled-grain percentage (HF) and two check large-panicle varieties with low filled-grain percentage (LF) were field-grown in 2012 and 2013. The number of spikelets per panicle of HF and LF both exceeded 300, and the filled-grain percentage (%) of HF was approximately 90, while that of LF was approximately 75 over the two years. The results showed that when the values were averaged across two years, HF yielded 12.9 t ha−1, while LF yielded 11.0 t ha−1. HF had a greater leaf area duration, biomass accumulation and transport of carbohydrates stored in the culm to the grains from heading to maturity compared with LF. HF exhibited a higher leaf photosynthetic rate, more green leaves on the culm, and higher root activity during filling phase, especially during the middle and late filling phases, in relative to LF. The length of HF for upper three leaves was significantly higher than that of LF, while the angle of upper three leaves on the main culm was less in both years. Meanwhile, specific leaf weight of HF was significantly higher when compared with LF. In addition, the grain filling characteristics of HF and LF were investigated in our study. Our results suggested that a higher leaf photosynthetic rate and root activity during filling phase, greater biomass accumulation and assimilate transport after heading, and longer, thicker and more erect upper three leaves were important morphological and physiological traits of HF, and these traits could be considered as selection criterion to develop large-panicle varieties with high filled-grain percentage.

Late-maturity type of Yongyou japonica/indica hybrids series (LMYS) have shown great yield potential, and are being widely planted in the lower reaches of Yangtze River, China. Knowledge about suitable growing zone and evaluation of yield advantage is of practical importance for LMYS in this region. Fifteen LMYS, two high-yielding inbred japonica check varieties (CK-J) and two high-yielding hybrid indica check varieties (CK-I) were grown at Xinghua (119.57°E, 33.05°N) of Lixiahe region, Yangzhou (119.25°E, 32.30°N) of Yanjiang region, Changshu (120.46°E, 31.41°N) of Taihu Lake region, and Ningbo (121.31°E, 29.45°N) of Ningshao Plain in 2013 and 2014. The results showed that maturity dates of the 15 were later than the secure maturity date at Xinghua and 6, 14 and 15 LMYS were mature before the secure maturity date at Yangzhou, Changshu and Ningbo, respectively. One variety was identified as high-yielding variety among LMYS (HYYS) at Yangzhou, 8 HYYS in 2013 and 9 HYYS in 2014 at Changshu, 9 HYYS at Ningbo. HYYS here referred to the variety among LMYS that was mature before the secure maturity date and had at least 8% higher grain yield than both CK-J and CK-I at each experimental site. Grain yield of HYYS at each experimental site was about 12.0 t ha−1 or higher, and was significantly higher than CK varieties. High yield of HYYS was mainly attributed to larger sink size due to more spikelets per panicle. Plant height of HYYS was about 140 cm, and was significantly higher than check varieties. Significant positive correlations were recorded between duration from heading to maturity stage and grain yield, and also between whole growth periods and grain yield. HYYS had obvious advantage over check varieties in biomass accumulation and leaf area duration from heading to maturity stage. Comprehensive consideration about safe maturity and yield performance of LMYS at each experimental site, Taihu Lake region (representative site Changshu) and Ningshao Plain (representative site Ningbo) were thought suitable growing zones for LMYS in the lower reaches of Yangtze River. The main factors underlying high yield of HYYS were larger sink size, higher plant height, longer duration from heading to maturity stage and whole growth periods, and higher biomass accumulation and leaf area duration during grain filling stage.