Search

Calculation of time derivatives of refrigerant pressures is important for dynamic simulation of heat exchangers in vapor compression cycles, i.e., typically the condenser and evaporator. This technical brief presents an experimental study on the pressure transient for the condenser and evaporator of a screw chiller with R134a, along with the analysis for the associated time derivatives. The experimental results from eight test cases suggest that the time derivatives of the condenser and evaporator pressures at their inlet are extremely close to those at the respective outlets. This observation can thus justify the key assumption of equal time derivatives of pressures in the dynamic modeling of heat exchangers, which in consequence improves the numerical efficiency and/or convergence, especially for large and complex thermalfluid systems. [ABSTRACT FROM AUTHOR]

To develop a better defrosting control system on finned evaporators of a refrigeration system, a study is conducted to better quantify the frosting and defrosting processes by using an infrared thermometer to determine the frost surface temperature. For gradual frost deposition a slow variation in surface emissivity is expected, while the defrosting process is characterized by a sudden change of this property. As an indicator for the defrosting initiation control mechanism, the times at which the IR signals stabilize at different conditions (Reynolds number, cold surface temperature, and ambient temperature) are reported along with the terminal mass concentration of a defined frosting process. On the other hand, the abrupt variation of surface emissivity indicates the termination of the defrosting process. Removable fins are used to measure frost weight, and a video microscope is used to determine the frost thickness. Defrosting initiation time and durations marked by melting, temperature are reported as a function of initial mass concentration and defrosting base surface temperature. The presented results could be used to design a better defrosting control system with better accuracy and energy saving features. [ABSTRACT FROM AUTHOR]

In the past, virtually all commercial computers were designed to operate at temperatures above the ambient and were primarily air-cooled. However, researchers have always known the advantages of operating electronics at low temperatures. This facilitates faster switching time of semiconductor devices, increased circuit speeds due to lower electrical resistance of interconnecting materials, and reduction in thermally induced failures of devices and components. Depending on the doping characteristics of the chip, performance improvement ranges from 1% to 3% for every 10 °C lower transistor temperature can be realized. The IBM S/390 high-end server system is the first IBM design which uses a conventional refrigeration system to maintain the chip temperatures below that of comparable air-cooled systems, but well above cryogenic temperature. In previous work, the focus was to study the effect of variation of evaporator outlet superheat on the flow through thermostatic expansion valve at varying evaporator temperature. The effect of change in bulb location and effect of bulb time constant on the hunting at the evaporator has been reported. The effect of area contact on the stability of the system is been predicted theoretically. Mechanical analysis is performed in order to check the stresses induced. The evaporator return line and the sensor bulb are simply attached. The effect of area contact is further studied experimentally on an experimental bench. [ABSTRACT FROM AUTHOR]