Search

The Simplified Method as reported in AASHTO and Federal Highway Administration (FHWA) manuals has been demonstrated to give poor predictions of unfactored reinforcement loads and strains, especially for geosynthetic reinforced soil walls. The writers have proposed the K-stiffness Method to improve the load prediction accuracy for walls under working stress (operational) conditions. However, it has also been recognized in recent publications by the writers and others that further improvements to the K-stiffness Method are needed. Furthermore, acceptance of the K-stiffness Method has been hindered due to its perceived complexity and the use of the plane strain friction angle to quantify the strength of the reinforced soil. This paper takes a fresh look at both methods and uses lessons learned from the K-stiffness Method development to improve the accuracy of the AASHTO/FHWA Simplified Method. Key parameters introduced during the development of the K-stiffness Method are applied to the Simplified Method and updated to further improve load prediction accuracy. Additional wall case histories have been added to the database used for the original K-stiffness Method to calibrate the new model and to broaden its utility. An important improvement is a single model that allows for seamless load prediction across a range of walls constructed with relatively extensible geosynthetic reinforcement and inextensible steel reinforcement materials. The quantitative improvement of the new model (Simplified Stiffness Method) compared to the current AASHTO/FHWA Simplified Method is demonstrated through statistical analysis of load bias values (i.e., the ratio of measured to predicted reinforcement load). [ABSTRACT FROM AUTHOR]

A high-density polyethylene (HDPE) geogrid soil-reinforced dry-cast concrete block retaining wall 6.3-m high was designed using the K-stiffness method as part of a highway-widening project southeast of Seattle, Washington. The amount of reinforcement needed for the original wall design using the K-stiffness method was approximately 50% of that required using the AASHTO simplified method. This paper describes the construction, instrumentation program, and interpretation of the measurements. Geogrid strains were measured using strain gauges and extensometers attached to reinforcement layers. An extensive materials testing program was conducted to characterize the backfill soil properties and geogrid stiffness properties and to calibrate strain gauge readings. The reinforcement loads deduced from the measured strains are compared with Class A, B, and C1 predictions using the AASHTO simplified and K-stiffness methods. These comparisons demonstrate that the simplified method significantly overestimated reinforcement loads, whereas the K-stiffness method provided estimates that were consistent with the measured results. This paper describes lessons learned, the influence of construction activities on wall performance, and the limitations of both methods in estimating connections loads. [ABSTRACT FROM AUTHOR]