Search

Abstract: Multiphase fluid motion in unsaturated fractures and fracture networks involves complicated fluid dynamics, which is difficult to model using grid-based continuum methods. In this paper, the application of dissipative particle dynamics (DPD), a relatively new mesoscale method to simulate fluid motion in unsaturated fractures is described. Unlike the conventional DPD method that employs a purely repulsive conservative (non-dissipative) particle–particle interaction to simulate the behavior of gases, we used conservative particle–particle interactions that combine short-range repulsive and long-range attractive interactions. This new conservative particle–particle interaction allows the behavior of multiphase systems consisting of gases, liquids and solids to be simulated. Our simulation results demonstrate that, for a fracture with flat parallel walls, the DPD method with the new interaction potential function is able to reproduce the hydrodynamic behavior of fully saturated flow, and various unsaturated flow modes including thin film flow, wetting and non-wetting flow. During simulations of flow through a fracture junction, the fracture junction can be fully or partially saturated depending on the wetting property of the fluid, the injection rate and the geometry of the fracture junction. Flow mode switching from a fully saturated flow to a thin film flow can also be observed in the fracture junction. [Copyright &y& Elsevier]

• A new weakly-compressible SPH model is proposed to simulate the multi-phase flows with large density ratios. • The SPH model removes unnecessary contributions from different phases for immiscible multi-phase flows. • The SPH model improves both the stability and accuracy across the multi-phase interfaces. • The SPH model allows the use of larger CLF numbers to greatly improve computational efficiency. The discontinuity across interface of multi-phase flows with large density ratios usually poses great challenges for numerical simulations. The smoothed particle hydrodynamics (SPH) is a meshless method with inherent advantages in dealing with multi-phase flows without the necessity of tracking the moving interfaces. In this paper, we develop a new weakly-compressible SPH model for multi-phase flows with large density ratios while allowing large CFL numbers. In the present SPH model, the continuity equation is first modified by eliminating the influence from particles of different phases based on the simple fact that different phases will not contribute when calculating the density for immiscible multi-phase flows; thus, the modified continuity equation will only consider the influence from neighboring particles of the same phase. The pressure and density of the particles of other phases are then re-initialized by using the Shepard interpolation function. The present multi-phase SPH model has been tested by four numerical examples, including the two-phase hydrostatic water, standing waves, liquid sloshing, and dam breaking. It has been demonstrated that the present multi-phase SPH model can obtain satisfactory results stably, even at large CFL numbers, and this means that large time steps can be employed. Therefore, the present multi-phase SPH model can significantly save computational cost through using large time steps, especially for large-scale problems with a large number of particles. [ABSTRACT FROM AUTHOR]