Search

This work consisted in characterizing of calcined laterite and oyster shell powder based blended geopolymer binders. To do this, raw laterite taken from Soa in the city of Yaoundé and oyster shells extracted from Mouanko in the Sanaga-Maritime were initially air-dried, then dried at 105 °C, before being calcined at 500 °C and 200 °C respectively for 2 hours. These samples were subjected to preliminary studies, i.e. determination of their chemical and mineralogical compositions, particle size distributions, densities, as well as thermal analysis for the synthesis of geopolymer binders. X-ray diffractometry, thermal and gravimetric analysis were carried out on the oyster shell powder and laterite, in order to elucidate the time and degree of calcination of the two samples, the evolution of the linear shrinkage, the setting time as well as the compressive and flexural strengths of the geopolymer binders. The results obtained show that oyster shells are rich in CaCO3 and contain crystalline phases, while laterite is rich in silica, iron (FeCO3) and alumina (Al2O3). The geopolymer samples: Lat + 0% oyster shells have a setting time between 125 and 168 min for a compressive strength of about 47 MPa. The peak strength is observed around 15% addition of oyster shell powder, i.e. 53.5 MPa at 28 days with an increased setting time. This strength was decreased from 25 % of addition of oyster shells, despite the increase observed in the setting time. It appears from this study that the addition of 15% oyster shell increases the compressive strength of the geopolymer, but also leads to a considerable decrease in absorption rate. Above this rate, the compressive strength decreases drastically and concomitantly the setting time increases.