Search

A method for the analysis of serotonin (5-HT) and its precursors, 5-hydroxytryptophan (5-HTP) and l-tryptophan (TP) in chocolate samples by capillary liquid chromatography-mass spectrometry (cLC-MS) has been developed. Optimum chromatographic conditions were established by using a personalized multifactorial experimental design. Finally the cLC separation was achieved through a mixture of acetonitrile and 5mM ammonium formate at pH 4 (3:97, v/v) as mobile phase in gradient elution, setting the injection volume at 10 μL and using pure water as injection solvent for focusing purposes on the head of the capillary column. For extraction of targets in chocolate samples a new, fast and simple procedure based on the use of acidic extraction medium and sonication was developed. Working in selected ion mode (m/z 177 for 5-HT, m/z 205 for l-tryptophan and m/z 221 for 5-HTP) detection limits were between 0.01 and 0.11 μg g(-1) and linearity was in the concentration range of 0.5-25 μg g(-1). Recoveries higher than 76% with RSDs lower than 8% were obtained from spiked samples for all analytes, showing the effectiveness of the proposed method. Serotonin and its precursors were determined in 5 kinds of commonly consumed chocolates with different cocoa contents (70-100%). The highest serotonin content was found in chocolate with a cocoa content of 85% (2.93 μg g(-1)). Regarding l-tryptophan, the highest content of this amino acid (13.27-13.34 μg g(-1)) was found in chocolate samples with the lowest cocoa content (70-85%). 5-Hydroxytryptophan was not detected in any chocolate samples., (Copyright © 2011 Elsevier B.V. All rights reserved.)

This paper describes a multivariate approach to study the effect on chromatographic conditions and to optimize such conditions in capillary liquid chromatography when high injection volumes are required. Several separations have been evaluated by using isocratic and gradient solvent elution, as well as isocratic elution combined with temperature programming. In this study, easily ionisable organic compounds with low logP have been used as representative analytes. Injection volume and nature of the injection solution have been evaluated in order to increase the sensitivity (peak area) and column performance (N values). The equations obtained by multiple linear regressions and response surfaces allow achieving the optimum on-column focusing conditions for chlorophenoxy acids, carbamates and heterocyclic amines., (Copyright © 2010 Elsevier B.V. All rights reserved.)

In the present paper, we have developed a capillary liquid chromatography with MS detection for the determination at ngg⁻¹ levels of four heterocyclic aromatic amines (MeIQx, norharman, harman and harmine), a group of mutagenic and carcinogenic compounds that can potentially be produced in protein-rich food during processing operations. They have been determined in commercial ready-to-eat (RTE) smoked salmon and soft cheese treated with E-beam irradiation. On the basis of experimental design studies and operating conditions of MS detector, best chromatographic conditions were obtained using a Luna® C¹⁸ capillary column (150 mm × 0.3 mm I.D.) with a mixture of acetonitrile-ammonium formate 5 mM pH 3.6 buffer (13:87, v/v) as mobile phase. To improve sensitivity, large injection volumes (20 μL) and injection solutions of low elution strength were employed. Sample preparation procedure included a previous treatment with 1M NaOH, followed by two solid-phase extraction steps; firstly on diatomaceous earth and then on mixed-mode cartridges. Heterocyclic amines were detected neither in irradiated and in non-irradiated samples, indicating that they were not formed by the radiation effect even at doses higher than those indicated in the Food Safety Objective established by regulatory agencies. RTE food samples were spiked at concentration levels in the range 10-30 ngg⁻¹. Recoveries higher than 85% (n=3 for each spiked level) were obtained, showing the effectiveness of the proposed methodology., (Copyright © 2010 Elsevier B.V. All rights reserved.)

In this work, the effect of temperature in isothermal and programmed modes on several chromatographic parameters such as retention factor, selectivity, resolution and plate number has been discussed. A critical comparison of isocratic/isothermal, gradient/isothermal and isocratic/program temperature modes has been made. Two representative families of pesticides have been selected for this study. One includes ionisable chlorophenoxy acids and two of their esters, some of which show similar polarities. The other one contains several weakly polar carbamates. Analysis was carried out using a reversed-phase capillary high-performance liquid chromatography (HPLC) system and focusing technique with UV or diode array detection (DAD).

A capillary liquid chromatography (cLC) method with gradient elution has been used to determine chlorophenoxy acid herbicides: 2,4-dichlorophenoxyacetic acid, 4-chloro-2-methylphenoxyacetic acid, 2-(2,4-dichlorophenoxy)propanoic acid, 2-(4-chloro-2-methylphenoxy)propanoic acid, 4-(2,4-dichlorophenoxy)butanoic acid, 4-(4-chloro-2-methylphenoxy)butanoic acid, 2-(2,4,5-trichlorophenoxy)propanoic acid, 2,4-dichlorophenoxyacetic-1-methyl ester and 2,4-dichlorophenoxyacetic-1-butyl ester in spiked apple juice samples with amounts between 0.025 and 0.150 mg kg(-1) of each herbicide. Clean-up and preconcentration of acid and esters were carried out in an Oasis MCX polymer. Detection limits obtained by cLC, between 0.005 and 0.018 mg kg(-1), allowed the determination of chlorophenoxy acids and their esters in apple juice samples around the levels permitted by the European Regulations, with recoveries in the range 84-99% and RSDs between 1 and 4%.

Solid-phase extraction is an attractive alternative in sample preparation because it overcomes many drawbacks of liquid-liquid extraction and makes on-line determination possible by hyphenation with chromatographic techniques. Driven by the need for more effective and more selective sorbents, advances in solid-phase extraction include the development of new materials. This paper describes different types of chemically modified sorbents for the solid-phase extraction of compounds from aqueous samples. Chemical introduction of different functional groups into a polymeric resin improves the efficiency of solid-phase extraction by providing better surface contact with the aqueous samples; also, these sorbents have a greater capacity than the typical solid-phase materials for polar compounds have. The most important new sorbents are the chemically modified resins based on styrene-divinylbenzene copolymers. Preparation of these new sorbents is described, and advantages and drawbacks of off-line procedures and on-line procedures are also discussed. Applications for off-line and on-line chromatographic determinations of polar compounds are presented.

The efficiency of an adsorbent consisting of quinolin-8-ol immobilized on controlled-pore glass which was packed in a minicolumn to preconcentrate nitrophenols in the presence of iron(III) has been established. Retention was carried out at acidic pH in the presence of 20 mM iron(III). Methanol-30 mM formic acid-sodium formate aqueous solution (pH 4.2) (65:35) was used in a one-step elution. Determinations were carried out by using liquid chromatography with detection at 350 nm. Determination of trace amounts of dinoseb in lemon juice was carried out with a minimum sample preparation. Recoveries were between 89 and 100% at 200-33 micrograms l-1. The maximum admissible concentration in fruit juice dictated by the Spanish and European Community legislation can be measured.