Search

Nitrobenzene, a potentially harmful compound found in tobacco smoke, has been largely excluded from prior analysis due to difficulties with quantification. Quantifying harmful compounds in cigarette smoke is useful to compare products, to examine the impact of design parameters on delivery, and to help estimate exposures. A sensitive high-throughput method has been developed for quantifying nitrobenzene in machine-generated mainstream cigarette smoke using isotope dilution gas chromatography-tandem mass spectrometry (ID-GC-MS/MS). This method has sufficient sensitivity to measure vapor phase nitrobenzene concentrations in the low nanogram range, with a 418 pg/cig method limit of detection. Precision estimates from two quality control cigarette products resulted in percent relative standard deviations of 11.5% and 14.9%; product variability estimates from 13 cigarette products resulted in percent relative standard deviations ranging from 2.8% to 16.9%. Nitrobenzene in the machine-generated, mainstream smoke from 15 cigarette products are reported and range from 18 to 38 ng/cig under the Health Canada Intense smoking regimen.

Despite nearly 80 years of advancements in gas chromatography (GC), indirect chemical matrix effects (MEs), known as the matrix-induced response enhancement effect, still occur to cause a high bias in the GC analysis of susceptible analytes, unless precautions are taken. Matrix-matched calibration is one common option used in GC to compensate for the MEs, but this approach is usually inconvenient, imprecise, and inefficient. Other options, such as the method of standard additions, surface deactivation techniques, chemical derivatizations, priming the GC, and/or use of internal standards, also have flaws in practice. When methods are accommodating, the use of analyte protectants (APs) can provide the best practical solution to not only overcome MEs, but also to maximize analyte signal by increasing chromatographic and detection efficiencies for the analytes. APs address the source of MEs in every injection by filling active sites in the GC inlet, column, and detector, particularly in GC–MS, rather than the analytes that would otherwise undergo degradation, peak tailing, and/or diminished response due to interactions with the active sites. The addition of an adequate amount of APs (e.g. sugar derivatives) to all calibration standards and final extracts alike often leads to lower detection limits, better accuracy, narrower peaks, and greater robustness than the other options to compensate for MEs in GC. This article consists of a critical review of the scientific literature, proposal of mechanisms and theory, and re-evaluation studies involving APs for the first time in GC-orbitrap and GC–MS/MS with a high-efficiency ion source design. The findings showed that 1 µg each of co-injected shikimic acid and sorbitol in the former case, and 1 µg shikimic acid alone in the latter case, led to high quality results in multi-residue analysis of pesticides and environmental contaminants., R.R.R. would like to thank to the International Mentoring Foundation for the Advancement of Higher Education (IMFAHE) organization for the fellowship to spend 4 months as a visiting scientist with the USDA. USDA authors thank ThermoFisher Scientific for loan of the GC-orbitrap instrument.

Several calibration approaches were evaluated for the quantitation of volatile organic compounds in air using miniaturized exhaustive and non-exhaustive sampling techniques, such as in-tube extraction (ITEX) and solid phase microextraction (SPME) Arrow. Eleven compounds, 2-ethyl-hexanol, hexanal, nonanal, toluene, ethyl-benzene, methyl isobutyl ketone, acetophenone, p-cymene, alpha-pinene, trimethylamine and triethylamine, all them found in the natural air samples, were selected as model analytes. Liquid injection, liquid standard addition to the sorbent bed and gas phase standards provided by an automatic permeation system, were evaluated in the case of ITEX packed with laboratory-made 10% polyacrylonitrile (PAN) material. Two different approaches, based on sampling of gas phase compounds from the permeation system and from sample vial containing gas phase standards, were evaluated for SPME Arrow with two different coatings, commercial divinylbenzene-poly(dimethylsiloxane) (DVB-PDMS) and laboratory-made mesoporous Mobil Composition of Matter No. 41 (MCM-41). In addition, interface model approach was used for the calculation of the real concentration of the target analytes in the sample from the total amount of analytes injected into the GC-MS in the case of SPME Arrow. Similar results were obtained with the different approaches used for the quantitation by ITEX and SPME Arrow. However, the use of gas phase standards with sample matrix similar to the natural samples, allowed the permeation system to provide the most reliable results for the quantitation of the target analytes. For this approach, linearity (expressed as r(2) values) ranged between 0.991 and 0.999. The limit of detection ranged from 0.5 mu g/m(3) (trimethylamine, MCM-41) to 2.2 x 10(-4) mu g/m(3) (methyl isobutyl ketone, MCM-41). In addition, the use of the fully automated permeation system provided good reproducibility values that were between 1.4% (acetophenone, MCM-41) and 7.8% (methyl isobutyl ketone, 10% PAN). The linear ranges were at least 3 order of magnitude for all the studied analytes with the exception of the calibration curve developed for trimethylamine with SPME Arrow (linear ranges between LOQ and 4.9 mu g/m(3) (DVB-PDMS) and LOQ and 9.8 mu g/m(3) (MCM-41)). (C) 2019 Elsevier B.V. All rights reserved.

This study describes a method based on direct contact sorptive tape extraction followed by on-line thermal desorption gas chromatography-mass spectrometry (DC-STE-GC-MS) to detect and quantify a group of suspected volatile allergens on the European Union (E.U.) list and a related compound on the skin (the stratum corneum) of volunteers treated with a cream of known composition fortified with the reference allergens. The following compounds were tested: citronellol, Z-citral (neral), geraniol, cinnamaldehyde, anisyl alcohol, cinnamyl alcohol, eugenol, methyleugenol, coumarin, isoeugenol, alpha-isomethylionone, 2-(4-tert-butylbenzyl)propionaldehyde (lilial), alpha-amylcinnamaldehyde, alpha-hexylcinnamaldehyde. Sorptive tape extraction (STE) is a sorption-based sampling technique in which a flexible polydimethylsiloxane (PDMS) tape is used to recover analytes by direct contact with the surface of a solid matrix or from the headspace in equilibrium with it. The reliability of the method was confirmed by: (i) allergen recoveries varying from 52.3% for lilial to 95.7% for neral, (ii) linearity in the range 10-150ppm, with regression coefficient R(2) always above 0.97, (iii) repeatability of each analyte, RSD% never exceeding 10%, (iv) intermediate precision, always below 15%, and (v) LOD and LOQ in the ppb range, therefore fully compatible with E.U. prescriptions (ppm). Other parameters such as substantivity analyte, approximate permeation through skin and influence of different nature of stratum corneum on recovery were also investigated. The method was also successfully applied to five commercially available creams declared to contain some of the allergens in question spread on the skin of the same volunteers.

For practical chromatographers it is extremely difficult to judge the merits and limitations of new technological developments. On the other hand, it is nearly impossible for those at the forefront of technology to judge the implications of their efforts for all specific applications of chromatography. Both chromatographers and researchers can be aided by a classification of the numerous specific applications into a few well-defined categories. In this paper, we propose such a classification of all chemical analysis by chromatography into three generic types of applications, viz. target-compound analysis, group-type separation, and fingerprinting. The requirements for each type are discussed in general terms. The classification scheme is applied to assess the benefits and limitations of comprehensive two-dimensional gas chromatography (GCxGC) and the possible additional benefits of using multivariate-analysis (MVA) techniques for each type of application. The conclusions pertaining to the generic types of applications are indicative for the implications of new developments for specific chemical analysis by chromatography. © 2004 Elsevier B.V. All rights reserved.

The preparation and mesomorphic properties of a substituted bis(dithiolene)nickel complex derived from 4, 4′-dimethoxybenzil are reported. The phase transition temperatures were based on data obtained by polarized light microscopy and differential scanning calorimetry. The mesogenic phase existed over the temperature range from 77 to 175 °C. A novel micropacked column (1.5 or 3 m ×1 mm i.d.) prepared from the slurry of bis[1,2-bis(4-n-undecyloxyphenyl)ethane-1,2-dithiolene] nickel(II) (5%, w/w), coated on Chromosorb W was applied for the separation of dialkyl sulfides. The non-linearity (discontinuity) of Van’t Hoff plots suggests that the liquid crystal property existed even in the coated phase. Factors affecting the retention and the sample selectivity on the prepared column were examined by using a flame photometric detector (FPD). The separation might be based on the mechanism of ligand exchange, shape selectivity and polarity interaction besides the vapor pressure. LOD for the determination of dialkyl sulfides was below 1 ng for most of the analytes.