Search

Calcium activates full-length myosin Va steady-state enzymatic activity and favors the transition from a compact, folded "off" state to an extended "on" state. However, little is known of how a head-tail interaction alters the individual actin and nucleotide binding rate and equilibrium constants of the ATPase cycle. We measured the effect of calcium on nucleotide and actin filament binding to full-length myosin Va purified from chick brains. Both heads of nucleotide-free myosin Va bind actin strongly, independent of calcium. In the absence of calcium, bound ADP weakens the affinity of one head for actin filaments at equilibrium and upon initial encounter. The addition of calcium allows both heads of myosin Va.ADP to bind actin strongly. Calcium accelerates ADP binding to actomyosin independent of the tail but minimally affects ATP binding. Although 18O exchange and product release measurements favor a mechanism in which actin-activated Pi release from myosin Va is very rapid, independent of calcium and the tail domain, both heads do not bind actin strongly during steady-state cycling, as assayed by pyrene actin fluorescence. In the absence of calcium, inclusion of ADP favors formation of a long lived myosin Va.ADP state that releases ADP slowly, even after mixing with actin. Our results suggest that calcium activates myosin Va by allowing both heads to interact with actin and exchange bound nucleotide and indicate that regulation of actin binding by the tail is a nucleotide-dependent process favored by linked conformational changes of the motor domain.

Class IX myosins are unique among the many classes of known actin-based motors in that the tail region of these myosins contains a GTPase-activating protein domain for the small GTP-binding protein, Rho. Previous studies on human myosin-IXb indicate that this myosin is mechanochemically active and exhibits actin-binding properties similar to the processive motor, myosin-Va. Motility analysis of antibody-tethered myosin-IXb performed using the sliding actin filament assay indicates that this myosin does exhibit properties characteristic of a processive motor. Like myosin-Va, the velocity of myosin-IXb remains constant (38.2 +/- 1.2 nm/s) even at single motor/filament densities. At low motor densities, filaments can be seen passing through and pivoting about single points on the motility surface. Analysis of filament landing rates as a function of motor density also indicates that a single motor is sufficient for filament movement. However, in contrast to myosin-Va, which uses coordinated motion of its two heads to move processively along the filament, hydrodynamic and chemical cross-linking studies indicate that under the conditions tested, myosin-IXb is a single-headed motor consisting of a single heavy chain and associated light chains.

Brain myosin-Va consists of two heavy chains, each containing a neck domain with six tandem IQ motifs that bind four to five calmodulins and one to two essential light chains. Previous studies demonstrated that myosin-Va exhibits an unusually high affinity for F-actin in the presence of ATP and that its MgATPase activity is stimulated by micromolar Ca(2+) in a highly cooperative manner. We demonstrate here that Ca(2+) also induces myosin-Va binding to and cosedimentation with F-actin in the presence of ATP in a similar cooperative manner and calcium concentration range as that observed for the ATPase activity. Neither hydrolysis of ATP nor buildup of ADP was required for Ca(2+)-induced cosedimentation. The Ca(2+)-induced binding was inhibited by low temperature or by 0.6 m NaCl, but not by 1% Triton X-100. Tight binding between myosin-Va and pyrene-labeled F-actin in the presence of ATP and Ca(2+) was also detected by quenching of the pyrene fluorescence. Negatively stained preparations of actomyosin-Va under Ca(2+)-induced binding conditions showed tightly packed F-actin bundles cross-linked by myosin-Va. Our data demonstrate that high affinity binding of myosin-Va and F-actin in the presence of ATP or 5'-O-(thiotriphosphate) is induced by micromolar concentrations of Ca(2+). Since Ca(2+) regulates both the actin binding properties and actin-activated ATPase of myosin-Va over the same concentration range, we suggest that the calcium signal may regulate the mechanism of processivity of myosin Va.

The actin binding and ATPase properties, as well as the functional domain structure of chick brain myosin-V, a two-headed, unconventional myosin, is reported here. Compared to conventional myosin from skeletal muscle, brain myosin-V exhibits low K-EDTA- and Ca-ATPase activities (1.8 and 0.8 ATP/s per head). The physiologically relevant Mg-ATPase is also low (approximately 0.3 ATP/s), unless activated by the presence of both F-actin and Ca2+ (Vmax of 27 ATP/s). Ca2+ stimulates the actin-activated Mg-ATPase over a narrow concentration range between 1 and 3 microM. In the presence of saturating Ca2+ and 75 mM KCl, surprisingly low concentrations of F-actin activate the Mg-ATPase in a hyperbolic manner (KATPase of 1.3 microM). Brain myosin-V also binds with relatively high affinity (compared to other known myosins) to F-actin in the presence of ATP, as assayed by cosedimentation. Digestion of brain myosin-V with calpain yielded a 65-kDa head domain fragment that cosediments with actin in an ATP-sensitive manner and a 80-kDa tail fragment that does not interact with F-actin. The 80-kDa fragment results from cleavage one residue beyond the proline-, glutamate-, serine-, threonine-rich region. Our data indicate that the Mg-ATPase cycle of brain myosin-V is tightly regulated by Ca2+, probably via direct binding to the calmodulin light chains in the neck domain, which like brush border myosin-I, results in partial (approximately 30%) dissociation of the calmodulin associated with brain myosin-V. The effect of Ca2+ binding, which appears to relieve suppression by the neck domain, can be mimicked by calpain cleavage near the head/neck junction.

The concentration of ionized calcium required for the capping of barbed filament ends by villin is about 4 orders of magnitude lower than that required for the cutting activity of villin. Capping was 50% complete at about 10-30 nM Ca2+, a level expected in resting cells, whereas the cutting rate was half-maximal at about 200 microM, making it possible to completely separate filament capping from filament cutting. Analysis of capping in terms of coupled equilibria between calcium binding to villin and calcium-villin binding to the barbed ends of actin filaments gives a value of 10(16)-10(17) M-2 for the product of the two binding constants. By comparison the binding constant reported for the rapidly exchanging calcium sites on villin is 2 X 10(5) M-1 and that for binding of calcium-saturated villin to barbed ends has a minimum value of 10(11) M-1 giving a product of 2 X 10(16) M-1. The close similarity of the two sets of values suggests that capping is regulated by the rapidly exchanging calcium sites on villin. In terms of coupled equilibria the calcium requirement for filament capping decreases with increasing concentrations of free villin. The scant information on the mechanism of cutting allows only an estimate of the maximal value for the calcium-binding constant of the site regulating cutting which is about 2-5 X 10(3) M-1. Cutting is followed by rapid capping of the newly released barbed ends.