Search

Foreground mitigation is critical to all next-generation radio interferometers that target cosmology using the redshifted neutral hydrogen 21 cm emission line. Attempts to remove this foreground emission have led to new analysis techniques as well as new developments in hardware specifically dedicated to instrument beam and gain calibration, including stabilized signal injection into the interferometric array and drone-based platforms for beam mapping. The radio calibration sources currently used in the literature are broad-band incoherent sources that can only be detected as excess power and with no direct sensitivity to phase information. In this paper, we describe a digital radio source which uses Global Positioning Satellite (GPS) derived time stamps to form a deterministic signal that can be broadcast from an aerial platform. A copy of this source can be deployed locally at the instrument correlator such that the received signal from the aerial platform can be correlated with the local copy, and the resulting correlation can be measured in both amplitude and phase for each interferometric element. We define the requirements for such a source, describe an initial implementation and verification of this source using commercial Software Defined Radio boards, and present beam map slices from antenna range measurements using the commercial boards. We found that the commercial board did not meet all requirements, so we also suggest future directions using a more sophisticated chipset. [ABSTRACT FROM AUTHOR]

Since the fall of the Arecibo 305 m telescope platform on 2020 December 1, there has been much discussion of building a new Arecibo telescope or rebuilding the facility that was destroyed. In the collapse, the top of the three platform support towers was sheared off, and the feed arm fell free from the swinging platform and destroyed 25% of the dish. Fortunately, the Control Building, the home of the computers, spectrometers, masers, atomic clocks, 430 MHz Klystrons, etc., was spared. By replacing the main dish support cables and resurfacing with coarse mesh, the main dish can be repaired as a reflector for < HF operation. By replacing the damaged aluminum panels to make the dish whole again, RF operations at up to 500 MHz can be resumed. In this paper, we outline the steps that can be taken to restore High Frequency (HF, 3–30 MHz) ionospheric heating, 430 MHz ionospheric incoherent scattering radar, passive radio observations of satellite arcing and pulsars, and to extend the field of regard to 47∘ from the zenith. This would restore and improve much of the utility of the Arecibo dish. Part of this plan involves supporting, positioning and pointing novel point feeds from lightweight football-camera-like cables, strung from the rebuilt tower tops. It is believed that the dish may thus become broadly useful long before replacement facilities can be engineered and constructed. [ABSTRACT FROM AUTHOR]