Search

Nanostructured (FeCoNi)70Ti10B20 (at%) alloy was synthesized by mechanical alloying from elemental powder mixture of Fe, Co, Ni, Ti and B using ball milling. The effect of ball milling time on the evolution of structure and morphology was investigated by X-ray diffraction, scanning and transmission electron microscopy and differential thermal analysis. It was observed that the formation of solid solution of (FeCoNi)70Ti10B20 started from the very onset of the milling process. Crystallite size and lattice strains seemed to be leveled off after 20 h of milling with no further major changes. The milling process for longer periods introduced severe plastic deformations causing formation of amorphous phase of (FeCoNi)70Ti10B20. The amorphous alloy composition was confirmed by energy dispersive X-ray spectroscopy analysis that showed an excellent homogeneity of the alloying elements. The phase stability of the mechanically alloyed amorphous sample was further verified by employing high-temperature and high-pressure studies. The alloy samples heat-treated at 700 °C revealed crystallization of the amorphous phase. However, synchrotron-based high-pressure ambient temperature X-ray diffraction studies confirmed that the amorphous phase of the alloy remained stable up to the pressure of 30 GPa. The 50 h milled sample after being annealed at 350 °C showed improvement in the soft magnetic properties of the alloy, which was due to the probable elimination of the residual stress in the amorphous phase of the alloy powders.

In this study, the microstructures and mechanical properties of conventionally solidified Al 63 Cu 25 Fe 12 alloy after different heat-treatments were investigated. The microstructures of the as-cast and subsequently heat-treated samples were investigated by X-ray diffraction (XRD), scanning electron microscopy (SEM) and differential thermal analysis (DTA). The XRD results showed the presence of quasicrystalline icosahedral phase (i-phase) together with crystalline phases corresponding to β-AlFe(Cu) solid solution phase (β-phase) and τ-AlCu(Fe) solid solution phase (τ-phase). The SEM investigations clearly showed the formation of i-phase with pentagonal dodecahedra structure. However, the i-phase together with β-phase was also observed in the heat-treated samples and the peak intensity of the β-phase decreased with increasing heat-treatment temperature. From the DTA curves, the melting point of i-phase was determined as 890 °C for this alloy composition. Mechanical properties of the as-cast and subsequently heat-treated samples were measured by a Vickers indenter. Results showed that the microhardness ( HV ) and the elastic modulus ( E ) of the as-cast sample were around 598 kg fmm −2 (5.86 GPa) and 104 GPa, respectively. In addition, the characteristic of material plasticity ( δ H ) value was calculated to be 0.54.