Search

The visualization experiments for measuring departure diameter and frequency of vapor bubbles in the saturated nucleate boiling of distilled water have been carried out at atmospheric pressure. The experiments were carried out for an isolated single cylindrical tube and that for a tube bundle under pool and cross flow boiling conditions. The test setup was a stainless steel cuboidal tank of dimensions 400 mm ×  200 mm ×  180 mm provided with a 5  ×  3 staggered tube bundle with an equilateral triangular pitch of 1.95. The departure diameter and frequency were measured using a high-speed camera to understand the parametric behavior of the bubble departure characteristics in a tube bundle under pool and cross flow condition. The range of operating conditions was: (1) heat flux q ″ = 8 − 28 k W / m 2 , (2) wall superheat Δ T s a t = 7 − 22 K , (3) inlet mass flux G = 120 − 303.5 kg / m 2 s . The departure diameter and frequency were found to increase with an increase in the heat flux, but decrease with an increase in the mass flow rate. The local departure diameter and frequency were observed to increase as the neighboring tubes in the bundle were successively heated. Empirical correlations have been developed for departure diameter and frequency for saturated nucleate boiling under cross flow conditions incorporating the effect of the tube bundle. The correlations were found to predict experimental data within acceptable limit. [ABSTRACT FROM AUTHOR]

The boiling models use departure diameter and frequency in closure relations for the calculation of nucleate boiling heat flux. These parameters are normally derived from empirical correlations which depend heavily on experiments. While these parameters are studied mostly for saturated conditions, there is not sufficient data for the values of departure diameter and frequency in subcooled boiling. In this work, the bubble departure characteristics, i.e. the departure diameters and frequency have been measured using high speed visualization experiments with subcooled demineralized water at atmospheric pressure for nucleate pool boiling conditions. The water pool dimensions were 300  mm × 135  mm × 250  mm with four different heating elements to carry out the parametric studies of bubble departure behavior. The considered parameters were heater surface roughness, heater geometry and heater inclination along with the experimental conditions like degree of subcooling (Δ T sub = 5−20 K), superheat (Δ T sat = 1−10 K) and the heat flux. The departure diameters and frequencies were directly measured from the images captured. It was intended to generate the subcooled nucleate pool boiling data under a wide range of conditions which are not present in the literature. The departure diameter was found to increase with the wall superheat, heater size and the inclination angle while the liquid subcooling and surface roughness produced a damping effect on the diameter. The departure frequency was found to increase with the wall superheat and the inclination angle, but decreases with an increase in the heater size. The frequency increases with the degree of subcooling except very close to the saturation, and is unaffected by the surface roughness beyond a certain superheat value. [ABSTRACT FROM AUTHOR]