Search

In this study, low velocity impact (LVI) behaviors of composite laminates reinforced with fabrics of different architecture are investigated. Three kinds of fabric architecture, namely, two-dimensional plain woven (2D-P), three-dimensional orthogonal (3D-O) and three-dimensional angle interlock (3D-A), are prepared with Kevlar 29 (Kevlar) yarns. Composite laminates are manufactured with Kevlar fabrics and polypropylene (PP) resin. These composites are impact tested at 4 m/s and 6 m/s impact velocities. The post-impact response of the composites of different fabric architecture is studied. The results revealed that the impact resistance is mainly dependent on the in-plane stiffness of the laminates. The energy absorption ability is predominantly influenced by the existence of yarns in the thickness direction. The 3D composites absorbed 14–26% higher energy than the 2D laminates. Especially, 3D-A laminates exhibited a higher peak load (14.21–30.25%), more energy absorption (12.7–26.2%) and lower cone formation at the back of the target (25–39%) as compared to 3D-O and 2D-P composites. [ABSTRACT FROM AUTHOR]

The ballistic impact response of thermoplastic-based composite armors made from Kevlar ® fabric and polypropylene (PP) matrix has been investigated against ballistic test standard NIJ-STD 0106.01 Type IIIA. Kevlar ® fabrics of different architectures, namely 2D plain woven, 3D orthogonal and 3D angle interlock fabrics, were produced and used as reinforcements to fabricate composite armor panels, using compression molding technology. Interfacial property between PP and Kevlar ® was improved by adding a coupling agent called maleic anhydride grafted PP. Reduced density was observed in Kevlar ® thermoplastic-based composites as compared to that of the thermoset-based laminates. Ballistic impact tests were imparted with 9 mm full metal jacket (FMJ) on armor panels having different fabric architecture. Ballistic test results revealed that 2D armor was 2.4–7% more susceptible to damage than 3D armors. Hydrocode simulations were carried out using ANSYS AUTODYN v. 14.0 to obtain an estimate for the ballistic limit velocity and simulate failure modes. Post-impact damage patterns obtained from the simulations were compared with the experimental results to assess the performance of the simulations. Good correlation between the hydrocode simulations and experiments was found, both in terms of failure modes and damage patterns. 3D composite armors were able to confront the 9 mm FMJ projectile; however, the 2D plain woven armors failed. The increase in the ballistic limit from 2D plain woven armor to 3D orthogonal and 3D angle interlock armors was 16.44% and 20%, respectively, indicating the effect of fabric architecture. [ABSTRACT FROM AUTHOR]