Search

A novel standard trajectory design and tracking guidance used in the multiple active leap maneuver mode for hypersonic glide vehicles (HGVs) is proposed in this paper. First, the dynamic equation and multiconstraint model are first established in the flight path coordinate system. Second, the reference drag acceleration-normalized energy (D-e) profile of the multiple active leap maneuver mode is quickly determined by the Newton iterative algorithm with a single design parameter. The range to go error is corrected by the drag acceleration profile update algorithm, and the drag acceleration error of the gliding terminal is corrected by the aerodynamic parameter estimation algorithm. Then, the reference drag acceleration tracking guidance law is designed based on the prescribed performance control method. Finally, the CAV-L vehicle model is used for numerical simulation. The results show that the proposed method can satisfy the design requirements of drag acceleration under multiple active leap maneuver modes, and the reference drag acceleration can be tracked precisely. The adaptability and robustness of the proposed method are verified by the Monte Carlo simulations under various combined deviation conditions. [ABSTRACT FROM AUTHOR]

For traditional predictor-corrector guidance algorithm for reentry glide vehicle, it cost a lot of time to obtain predicted flight range with a slow speed to iterate. In this paper, according to residual network (ResNet)'s block and dynamic model of vehicle, through analyzing the characteristics of predicted flight range with constraints, the flight range prediction block and flight range prediction neural network are designed, which can obtain the predicted range accurately and quickly; then aiming at the separation between guidance logic and no-fly zone avoidance logic, which may lead to guidance failure and increasing of the sign variation number of the bank angle, the no-fly zone crossrange and the no-fly zone mapping crossrange are proposed in this paper. According the repulsion force of artificial potential field, an adaptive crossrange corridor combining guidance logic and no-fly zone avoidance logic is proposed, and the convergence of the corridor is analyzed theoretically. Through simulation, the block number of flight range prediction network is determined firstly. By this method, the efficiency of lateral guidance can be improved. Then, through the simulation with the different no-fly zones under different disturbed conditions, the stability and validity of the guidance method are verified. Finally, compared with other predictor-corrector algorithms, the proposed method can realize guidance with less sign variation number of bank angle and better avoidance for no-fly zones. [ABSTRACT FROM AUTHOR]

The paraglider, a flexible flying vehicle, consists of a parafoil with flexible wings, suspension lines, and a suspended payload. At this time, the suspension lines have several parameters to be designed. Above all, a parameter called Rigging Angle (RA) is sensitive to the aerodynamic characteristics of a paraglider during flight. In this study, the effect of RA is clarified using the two-dimensional stability analysis and a wind tunnel test. The mechanisms about the parafoil-type vehicle stability are clarified through the experimental and analytical approaches as follows. The RA has an allowable range for a stable flight. When the RA is set out of the range, the parafoil cannot fly stably. Furthermore, the behavior of the parafoil wing in the case of lower RA than the allowable range is different from the case of higher RA. The parafoil collapses from the leading edge of the canopy and cannot glide in the case of lower RA. [ABSTRACT FROM AUTHOR]

This paper addresses the analytical formation control and cooperative guidance problem for multiple hypersonic gliding vehicles under distributed communication. The gliding flight of the hypersonic gliding vehicle is divided into formation control phase and time coordination phase. In formation control phase, based on the idea of path tracking, the formation controller is designed using the second-order consensus protocol with normal positions as the coordination variables. In time coordination phase, based on the quasi-equilibrium gliding condition and the assumption of uniform deceleration motion, the analytical expression of time to go is derived. Then, the cooperative guidance method is developed using the first-order consensus protocol with time to go as the coordination variable. The proposed method takes full consideration of the characteristics of hypersonic gliding vehicle, such as complex nonlinear dynamics, no thrust, and quasi-equilibrium gliding condition, and no online numerical iteration is needed, which is well applicable for hypersonic gliding vehicles. Simulation results demonstrate the effectiveness of the formation control and cooperative guidance method. [ABSTRACT FROM AUTHOR]