Search

Machining optimization has been studied for low machining cost, high production rate, and energy saving. Nevertheless, most of the studies did not consider the part geometry. The complex part geometry results in varying contact conditions between the cutting tool and the workpiece. Therefore, the conventional tool life equation may not be applicable, and it is impossible to expect the same performance of machining different parts even with the same cutting parameters. In addition, the amount of material removal is different from part to part. Either the underuse or overuse of the tool is considered production loss in machining process. As a result, it is better for the cutting tool to be utilized until it reaches the end of its life when the operation is completed. Taking the conditions above into considerations, an objective function including the machining cost and the loss of tool usage is proposed in this study. Three turning operations, one straight turning and two profiling, were investigated to show the effect of part geometry on the machining optimization and tool wear. The results showed the different optimization processes and tool wear patterns although the initial cutting parameters and the amount of material removal were identical. The optimization processes were converged in 5 iterations. The cost of three cases reduced 34%, 33%, and 19%, respectively, with different optimized cutting parameters, and the tool approached the end of its life when the operation was done. [ABSTRACT FROM AUTHOR]

This paper presents the result of pulsating lubrication strategy (PLS), an alternative metalworking fluids approach to improve machining performance. The formation of built-up edge (BUE) and built-up layer (BUL) is among the problems encountered during the machining of aluminum alloy, which degrades cutting performance and thus affects the machined surface quality. This study focuses on chip removal effectiveness by jetting a coolant intermittently of PLS on the cutting tool to create a hydraulic shock. The water stream coolant was set to pulsate at 2000 pulse/min with the pressure of 0.76 MPa. Applying this method improves chip evacuation. Hence, minimizing the formation of BUE and BUL more effectively than dry cutting. [ABSTRACT FROM AUTHOR]

Since the 1960s, the Inconel Alloy 718 has been a standard nickel-based superalloy due to its high strength, balanced mechanical properties, and strong corrosion resistance at relatively low costs and has been widely used in critical aircraft engine components. With the aim of improving productivity and product quality by implementing advanced tools and new process designs, models such as the FE model are utilized to predict the machining performance such as the cutting forces, the tool life, and the surface integrity. In the research area of FEM chip formation simulation, the influence of flank wear on predictions has not been investigated, especially not on the underestimation of the cutting normal force. In this paper, a 2D FEM chip formation model with the coupled Eulerian-Lagrangian (CEL) method has been built to predict cutting forces as well as other material loadings (Brinksmeier et al. Procedia CIRP 13:429–434, 2014; Buchkremer and Klocke Wear 376-377:1156–1163, 2017) in the machining of Direct Aged 718. In order to validate the performance of the FE model, fundamental investigations have been performed in orthogonal cutting with different cutting parameters. Two kinds of cemented carbide cutting tools with different cobalt contents have been applied to achieve different tool wear behaviors. Moreover, the underestimation of the cutting normal force by FEM chip formation simulation has been investigated and solved in consideration of the flank wear. The introduced FE-modeling approach shows precise predictions in terms of the cutting forces and the chip formation. [ABSTRACT FROM AUTHOR]