Search

In the unfolding‐type interleaved two‐switch flyback inverter (ILTFI) operating in discontinuous conduction mode (DCM), the hybrid control strategy combining the one‐phase DCM and the two‐phase DCM has a significant impact on improving the efficiency under all load conditions. In the situation where the marginal power of this control strategy is increased, the converter may enter CCM. Consequently, the converter cannot track the reference current and the output current quality is notably decreased. To tackle this issue, a novel hybrid control method is proposed which varies the switching frequency based on the output power. The proposed approach is immune to the loss analysis and power losses of the components. Hence, it is independent of components selection and their characteristics. In this case, the smooth transition between the one‐phase and the two‐phase operation modes is guaranteed without affecting the output power quality and the stability of the converter in DCM. The control complexity of the proposed scheme is low and the converter can be easily controlled in DCM. The performance of the flyback microinverter with the proposed hybrid control scheme is verified by the simulation and the experimental results together with the loss analysis. [ABSTRACT FROM AUTHOR]

Perfect power system voltage stability is not possible in practice. Generally, the power grid is continually exposed to changes in its load and operating conditions. Therefore, dynamic stability analysis is one the most important and effective elements for greater security, stability and reliability of planning, design, operation and economic aspects of electric power networks. This study investigates and reports on the dynamic stability of the power system with a large‐scale photovoltaic system (L‐S PV). Two different scenarios with centralised PV power plants are considered in the medium voltage level without voltage regulation capabilities. Simulation results with these scenarios will show how the voltage instability decreases with the L‐S PV based on the bus status, disturbance location, and disturbance duration. In addition, the study discusses network terminal voltage, generator's rotor angle, generator's terminal current, generator's reactive power and electrical power output. This study is an extension of the earlier published conference paper. [ABSTRACT FROM AUTHOR]

In the case of operating in a weak grid system, when wind power becomes a significant portion of the power system or even the sole energy source, the wind power generators and converters are expected to help maintain the grid voltage. The grid‐side converter needs to work as a voltage source to help regulate the terminal (grid) voltage amplitude and frequency by adjusting the reactive power and active power flow, respectively. For a direct‐drive permanent magnet synchronous generator with a full power converter, the active power must be provided by the captured wind power. The active power flow between the source (captured wind power) and the grid (load) must be balanced by actively controlling the generator speed and wind turbine pitch angle. In the study, the coordinated control of generator speed and blade pitch angle is proposed together with a dc‐link voltage controller. A model of the grid‐side converter operating as a voltage source has been built and the strategy regarding voltage and frequency regulation is presented. Simulation is carried out with different wind and load profile. The results show the wind energy can help support the weak grid and power the local grid in stand‐alone mode as well. [ABSTRACT FROM AUTHOR]