Search

Even though shunt compensation of transmission lines (TLs) is a common practice to limit the overvoltages stemming from the Ferranti effect, it may cause transient and steady‐state resonant overvoltages when one phase is left open due to the single‐pole‐open condition following the temporary phase‐to‐ground (Ph‐g) fault. Furthermore, the existing shunt reactors potentially increase the duration of the secondary arc current at the fault point and hence prevent offering fast single‐pole reclosing. To exploit the mentioned issues, in recent studies, a neutral reactor is introduced, which is installed in the neutral point of the shunt reactors; nonetheless, obtaining the appropriate amount of it is remarkably challenging. In this paper, an optimal neutral reactor (ONR) is determined based on an optimization problem, which minimizes the neutral reactor cost subject to limiting both resonant overvoltages and the duration of the secondary arc current. In modelling, the Laplace domain is employed rather than the phasor domain to consider both transient and steady‐state conditions since this technique allows having better control over transient overvoltages as well as transient secondary arc. [ABSTRACT FROM AUTHOR]

Here, an optimization framework is proposed for the service restoration (SR) problem in distribution networks based on mixed‐integer second‐order cone programming (MISOCP). The objective function is to minimize (i) curtailed loads, (ii) the number of switching operations, (iii) crew dispatching cost, and (iv) operational cost. A novel approach is developed for the optimal switching crew routing (SCR) to perform the manual switching operations in a short time. Self‐healing actions including (i) network reconfiguration, (ii) load shedding, (iii) adjusting the output power of the dispatchable distributed generations (DGs), and (iv) the optimal tap setting of the voltage regulation devices are adopted in the SR strategy. Both the voltage dependency and the uncertainty nature of loads are modelled. Besides, the switch failure scenario is considered in the proposed model to deal with real operating conditions. Hence, the developed optimization framework offers the most robust SR solution. The simulation studies are performed on an actual 87‐bus system in MATLAB/Yalmip environment by adopting Gurobi solver. The obtained results verify that the proposed model enhances quality of the solution in terms of SR process time compared to the other existing models. [ABSTRACT FROM AUTHOR]

This study describes an actual problem with circulating current at the ground grid of an actual power system that has an air-core reactor. Such reactors generate a large amount of magnetic flux whose path can be closed through its underneath ground grid. This magnetic flux induces a voltage on the ground meshes and thus results in considerable circulating currents that pass through the ground meshes. Indeed, the main novelty of this study is investigating the effect of air-core reactors on the other nearby equipment and considering the air-core reactor's flux underneath ground meshes. This phenomenon occurred in a steel industrial plant and practically leads to severe damages to equipment through which the current has been flowing, including ground grid conductors, cable shields, and foundation armatures. This study addresses the origins of problems raised by the manufactured equipment in a reputable company based on both simulations and experimental studies. Based on the obtained results, several practical approaches are proposed and implemented to overcome the problems mentioned above. [ABSTRACT FROM AUTHOR]

This study introduces a predictive auto‐reclosure scheme based on faster‐than‐real‐time (FTRT) analysis for synchronous generator type of distributed generation (DG) units to decrease DG oscillations after successful reclosure and also enhance transient stability margin of the unit after unsuccessful reclosure. The FTRT analysis, as a new concept for the protective relaying, represents a powerful predictive auto‐reclosure scheme which is based on a state‐space model of the DG unit. After a fault scenario and the first operation of the associated breaker, the FTRT analysis predicts energy level of the DG unit and determines an optimum dead‐time corresponding to the minimum energy level of the DG unit for reclosure that can provide an appropriate margin for transient stability. The effectiveness and accuracy of the proposed method are verified based on a test system. The results confirm that the proposed approach can effectively enhance transient stability for unsuccessful reclosure and reduce the corresponding oscillations after reclosure. [ABSTRACT FROM AUTHOR]

Load dynamics play an important role in the voltage stability. Grid-side short-circuit faults may induce severe voltage drops at motor load buses. Once the fault is cleared, depending upon its clearing time, the load bus voltage may either return to its permissible range or degrade gradually until it collapses. From the short-term voltage stability viewpoint, the former is a stable phenomenon, while the latter is an unstable circumstance and the load should be shed in order to prevent voltage instability from being spread over the grid. To cope with this problem, this study presents a new under-impedance load shedding (UILS) scheme. A quadratic distance relay is used as the load shedding element. The trajectory of load impedance is monitored by the proposed UILS relay. Following the grid-side fault clearance, if the impedance trajectory enters the load shedding zone and remains inside it for a predefined time, voltage instability is detected and the load is curtailed by the UILS relay. The proposed approach is tested on various networks, including a real power system model. The obtained results approve the efficiency of the proposed UILS scheme. [ABSTRACT FROM AUTHOR]

Loss of excitation (LOE) event threatens both the generator and power system stability. Numerous approaches have been proposed for LOE detection, most of which use the impedance trajectory. Such methods may maloperate under system disturbances, especially power swings. This study presents a new approach for LOE detection by estimating the field flux linkage participation (FFLP) in the stator flux linkage. Intrinsically, this newly defined index mainly depends on the generator excitation system and thus highly reduces when an LOE takes place. The FFLP parameter can easily be calculated using stator voltage and current signals. All kinds of LOE events cannot be studied using most available simulation software. To cover all of them, utilising state variables, a generator model connected to a power system is implemented. Performed simulation studies demonstrate that the proposed strategy not only considerably decreases the LOE relay operation time, but also improves the LOE relay security against system disturbances. In addition, the proposed approach is experimentally evaluated on a 10 kVA synchronous generator. [ABSTRACT FROM AUTHOR]

Following large disturbances, the conventional under frequency load shedding (UFLS) relays may not operate properly, as they are designed to merely preserve the frequency stability of the system, independent of its voltage stability. In this study, an adaptive load shedding scheme is proposed to maintain the power system stability when the conventional scheme fails. In doing so, the frequency and its falling rate along with a properly defined voltage falling rate are exploited to determine closeness to the disturbance area and its severity. Accordingly, a proper amount of load is shed from the locations with the highest influence on the system stability. The proposed scheme exclusively utilises locally measured quantities and does not require a communication link. The associated logic is practical and can be easily appended to the existing UFLS relays to enhance their performance. To demonstrate the efficiency of the proposed UFLS scheme, it is applied to two large‐scale power systems where the exact load model is taken into account. The obtained results verify that a large number of blackouts because of inappropriate operation of conventional UFLS relays can be prevented using the proposed scheme. [ABSTRACT FROM AUTHOR]