Search

A large‐scale AC/DC hybrid power network has recently been constructed in China because of the fast development of high voltage direct current (HVDC) technology. The receiving AC system must have sufficient system strength to guarantee the safe operation of the DC side. The paradox is that raising the AC side system's strength will increase the short‐circuit current (SCC) level, endangering the safety of the system. In order to resolve the contradiction between the system strength of multi‐infeed DC receiving‐end power networks and SCC, this paper proposes an optimal transmission switching strategy. Firstly, the system strength is characterised by the multi‐infeed short‐circuit ratio (MISCR), followed by constructing a comprehensive constraint set that considers the MISCR and SCC simultaneously. Secondly, to optimize SCC with MISCR and N−1 safety constraints, a mixed integer linear programming model is developed. Finally, to enhance the computing performance for large power systems, a new connectivity constraint set and decision space reduction techniques are provided. The proposed method is tested for effectiveness using the IEEE 30‐bus and IEEE 118‐bus systems. [ABSTRACT FROM AUTHOR]

Equipment maintenance decision is a very critical technology in power grid asset management. The traditional maintenance decision focuses on the analysis of the operation performance of the equipment itself, but lacks the analysis and description of the fuzziness of power equipment outage parameters. Therefore, this paper establishes the reliability assessment model based on equipment health condition monitoring, which makes the maintenance decision transition from equipment level to system level, and the fuzzy mathematics theory is introduced to establish a model describing the fuzziness of equipment failure rate parameter to make system reliability assessment and equipment maintenance decision scheme. Firstly, this paper proposes a fuzzy failure rate model of power transformer based on condition monitoring. Then the fuzzy parameters are combined with the conventional probabilistic reliability assessment method to establish the fuzzy probability hybrid reliability assessment model of the transmission system, and the fuzzy maintenance reliability benefit index is defined and deduced. Finally, a maintenance strategy of transformer based on fuzzy probability hybrid reliability assessment and fuzzy set theory is proposed, and the case study is carried out on a regional power grid in East China. The results show that the proposed model provides an improved maintenance strategy of power equipment. [ABSTRACT FROM AUTHOR]

The development of foreign electricity markets has been relatively complete, while China's electricity market started late and the design of the market mechanism needs to be improved, so the selection of a suitable market model and the design of the market mechanism in hydropower‐rich regions is conducive to the healthy development of the electricity market. While most of the first eight pilot regions in China have entered the long‐period continuous operation stage, and all the second batch of six power spot pilots have started the simulation trial run. However, the construction of power markets in hydropower‐rich regions of China, Sichuan, and Yunnan, still faces multiple problems to be solved, such as ensuring the reliability of medium‐ and long‐term power supply, improving the efficiency of hydropower resources utilization and consumption scale, and maintaining the stability of market prices. In this paper, the authors establish a multi‐scale joint clearing model for different market models considering both long‐term and short‐term operation strategies, and conduct simulations of different market models at different time scales to compare and analyze the optimization results and electricity price fluctuations of different market models. It can stabilize the market price and reasonably reflect the true value of hydropower, and also promote the consumption of clean energy and guarantee the reliability of power supply in the medium and long terms. Finally, suggestions are made for the selection of electricity market models, the security of energy supply and the design of sustainable development mechanisms for hydropower in hydropower‐rich regions such as Yunnan and Sichuan in China, with a view to providing useful references for the construction of China's electricity market. [ABSTRACT FROM AUTHOR]

Pollution usually accumulates on the surface of the insulator rapidly on high‐speed electric multiple units (EMUs) under operation condition, and the flashover can occur frequently, especially when the EMUs is running on a high‐altitude line. To solve the problem, this paper proposes the calculation method of insulator withstand voltage under the condition of non‐uniform fouling distribution of high‐speed airflow based on the characteristics of high altitude of Lanzhou‐Xin Line in China, and gives the design and test verification of insulator support insulator for 3500‐km altitude. The design and test verification of the supporting insulator of the rolling stock applicable to 3500 km altitude are presented. The result shows that the insulator should be reliable operation on 4430‐km high altitude area if the insulator structure height is 430 mm, the creep distance is 1250 mm. The anti‐pollution performance is fine in high‐speed wind if the radiuses of the large and small shed of the insulator are 196 and 145 mm, respectively, and the shed spacing is 45 mm. The 50‐Hz withstand voltage of the developed insulator is 131 kV and the light impulse voltage is 228 kV which is suitable for lines running on 3500 m. This research provides a theoretical basis and data to support the safety of high‐speed rolling stock in high‐altitude areas. [ABSTRACT FROM AUTHOR]

The intermittent access of renewable energy sources leads to a significant increase in fault short‐circuit currents in power grid. DC superconducting fault current limiters (SFCL) can limit short‐circuit currents in flexible DC transmission systems, which work in combination with direct current circuit breaker (DCCBs) to protect the grid system effectively. However, for the parameter design of DC superconducting fault current limiter (DCSFCL), it is difficult to balance the economics of the device and its adaptability to different fault situations. In this paper, a cross‐mapping design methodology for the DCSFCL is proposed and applied in the Nan'ao flexible DC transmission project, China. A cross‐mapping method is designed combining the critical parameters of DCSFCL and the system parameters. A three‐terminal simulation model of the flexible DC transmission system is constructed through MATLAB/Simulink and the design process of DCSFCL parameters is introduced. A cyclic calculation approach is proposed for the design of DCSFCL parameters through three fault conditions of the power system. Meanwhile, impact current short‐circuits test and artificial ground short‐circuit test were conducted on the prototype. Test results show that the designed DCSFCL meets the requirements of practical applications. [ABSTRACT FROM AUTHOR]

Buildings near direct current transmission lines are sensitive to the electromagnetic environment, and the measurement of the electric field above them is important in engineering design and environmental assessment in China. The models of buildings and probes in the ion flow field were established to explore the accurate measurement method of the electric field above the building. Based on the upstream finite element method and the predictor–corrector method, the influence of whether the probe was grounded or not above the building was studied. On this basis, simulation experiments and real‐type experiments were carried out. The results show that when the electrical conductivity of the building was greater than 10−10 S/m, being grounded or not would not change the results. When the building conductivity was between 10−11 and 10−12 S/m, the electric field measurement results would be increased by 30% to 120% after grounding. In the real‐type experiments on the platform with a plywood roof, the relative error in the electric field when grounded or not was only 2.6%. This proved the reliability of the calculated results. In this paper, the measuring method of the DC space charge‐modified electric field above buildings was analyzed first, and the conclusion that ground wire can be cancelled above buildings with general materials was presented. The research results can provide a technical basis for the accurate measurement of the electric field above the buildings near DC transmission lines. [ABSTRACT FROM AUTHOR]

The China Energy Administration has issued policies to encourage energy storage to participate in the electric auxiliary service market, which will provide ideas for electric vehicle charging stations (EVCSs) to collectively participate in peak‐regulation and frequency modulation (FM). Taking into account the benefits of EVs participating in peak‐regulation and FM, this paper studies expansion planning for EVCSs. First, the orderly scheduling strategy of EVs under vehicle‐to‐grid (V2G) technology is established in this paper. And a peak regulation method is proposed to maximize the economic benefits of charging and discharging during peak and valley periods. Second, based on the temporal and spatial prediction model of EV charging demand, the expansion planning model of EVCSs is constructed considering the benefits of peak‐regulation and FM. Aiming at minimizing the comprehensive annual social cost of charging stations, the expansion site selection and capacity scheme of EVCSs are obtained. Finally, taking the 24 nodes in Xiangzhou District of Zhuhai City as an example, the location and capacity of the final annual expansion plan are obtained. And the influence of main control parameters on the results of the whole model and method is analysed in detail, the feasibility and effectiveness of the whole model and method are verified. [ABSTRACT FROM AUTHOR]

In the distribution network planning work, taking into account the constraints of funds and construction annual plan, there is always the prioritization problem of multiple MVDC distribution networks. Aiming at the problem, this paper proposes a method for the optimization analysis of MVDC distribution network planning objects. Firstly, a comprehensive evaluation index system of urban MVDC distribution network planning and optimization is established from three aspects of improving power supply reliability and the quality of voltage, MVDC distribution network scenario types and distribution network social benefits. Then, the qualitative indexes are quantified based on the cloud model, and the comprehensive evaluation values of each distribution network are calculated and sorted by the hierarchical additive weighting of Delphi entropy weight method. Taking the maximum comprehensive evaluation value of the scheme as objective function and the annual total investment as constraint, the construction priority of multiple MVDC distribution networks is determined. Finally, taking several distribution networks in Guangzhou, Guangdong Province, China as examples, the simulation results show that the optimal objects of distribution network based on the urban scenario demands are X4, X8 and X1, with the lowest total investment cost of 19,180 yuan, thus verifying the effectiveness of the proposed method. [ABSTRACT FROM AUTHOR]

Abnormal heating of composite insulators on ultra‐high voltage (UHV) transmission lines is widespread under high humidity and heat in southern China. The infrared imaging technology can be used of quickly and effectively detect insulators with abnormal heating and determine their defect types. However, it may cause misjudgement when the infrared images are not clear. A super‐resolution reconstruction method of infrared images of composite insulators with abnormal heating based on improved super‐resolution generative adversarial networks (SRGAN) is proposed in this paper, and the dense residual network in SRGAN is perfected by introducing the residual channel attention (ResCA). This method overcomes the problems that the resolution of images reconstructed by traditional methods is not significantly improved, and images are too smooth, and the edge details are easily lost. Compared with the traditional methods, the five reference‐free image quality evaluation indexes of the image reconstructed by the improved SRGAN are increased by −0.73% to 63.84%. Further the effectiveness and superiority of the improved SRGAN are verified by comparing the changes in the distribution of grey values of infrared images before and after reconstruction. Finally, the improved SRGAN is used to perform super‐resolution reconstruction of the low‐resolution infrared image examples. [ABSTRACT FROM AUTHOR]

Short‐term load forecasting is essential to power systems management. However, most existing forecasting methods fail to fully consider how to rationally integrate the intrinsic time‐related dimensions of electric load data and the decomposition methods into machine learning models so that their prediction accuracy and robustness still have much room for improvement. To solve this problem, this paper proposes a decomposition‐based multi‐time dimension long short‐term memory (DB‐MTD‐LSTM) model for short‐term electric load forecasting (STELF). In DB‐MTD‐LSTM, empirical mode decomposition with adaptive noise (CEEMDAN) is first introduced to smooth non‐linear non‐stationary electric load data and constrain the modal aliasing or noise of decomposed electric load data in the traditional decomposed method. A joint relevant time dimensions method (JRTDM) is then developed using autocorrelation analysis to rationally extract the temporal characteristics of decomposed data in multiple time dimensions. An improved LSTM called MTD‐LSTM is developed by combining JRTDM with LSTM, which can effectively apply multi‐dimensional time characteristics of the decomposed load to improve the predictive accuracy and robustness. Several datasets from Australia and China are performed to check the predictive performance of DB‐MTD‐LSTM. Experimental results verify that DB‐MTD‐LSTM has better predictive accuracy and satisfactory robustness compared with state‐of‐the‐art and conventional predictive models. [ABSTRACT FROM AUTHOR]

With the increasing proportion of wind power connected to grid, power system dispatching is facing more and more challenges from uncertainty. To cope with this uncertainty, robust optimization has been applied in unit commitment (UC) problem. In this paper, a multi-band uncertainty set considering the temporal correlation (MBUSCTC) of wind/load prediction error is proposed firstly, which has two characteristics: (1) The MBUSCTC rigorously and realistically reflect the distribution characteristics of uncertainties in uncertainty intervals, thereby effectively reducing the conservatism of the traditional singe-band uncertainty set; (2) the temporal correlation constraints of wind power/load prediction errors in MBUSCTC could limit the realization of uncertainties fluctuating frequently in uncertain intervals, thereby eliminating scenarios with lower probability in uncertainty sets. Then the proposed MBUSCTC is applied to UC problem, leading a robust UC model based on MBUSCTC, which is solved by Benders decomposition method and C&CG method. Finally, case studies based on the modified IEEE-118 bus system and an actual power system of China demonstrate that the proposed method can effectively reduce the conservativeness of the robust UC model and ensure the robustness of the unit commitment solution. [ABSTRACT FROM AUTHOR]