Search

A forward/reverse body bias generator (BBG) which operates under wide supply-range is proposed. Fine-grained body biasing (FGBB) is effective to reduce variability and increase energy efficiency on digital LSIs. Since FGBB requires a number of BBGs to be implemented, simple design is preferred. We propose a BBG with charge pumps for reverse body bias and the BBG operates under wide supply-range from 0.5 V to 1.2 V. Layout of the BBG was designed in a cell-based flow with an AES core and fabricated in a 65 nm CMOS process. Area of the AES core is 0.22 mm2 and area overhead of the BBG is 2.3%. Demonstration of the AES core shows a successful operation with the supply voltage from 0.5 V to 1.2 V which enables the reduction of power dissipation, for example, of 17% at 400 MHz operation.

This paper discusses the resistive termination of on-chip high-performance interconnects. Resistive termination is effective to improve the bandwidth of on-chip interconnects, on the other hands, increases the power dissipation and the area. Therefore trade-off analysis about resistive termination is necessary. This paper proposes a method to determine the termination of on-chip interconnects. The termination derived by the proposed method provides minimum sensitivity to process variation as well as maximum eye-opening in voltage.

This paper proposes a design technique to reduce the power dissipation of CML driver for on-chip transmission-lines. CML drivers can operate at higher frequency than conventional static CMOS logic drivers. On the other hand, the power dissipation is larger than that of CMOS static logic drivers. The proposed method reduces the power dissipation by using an impedance-unmatched driver instead of the conventional impedance-matched driver. Measurement results show that the proposed method reduces the power dissipation by 32% compared with a conventional design at 12.5 Gbps.

SUMMARY In this paper, we propose alternate self shielding to remove critical transitions of on-chip global interconnect. Our proposed method alternates shield and signal wires cycle by cycle. The conventional self-shielding methods need additional wires to remove critical transition by encoding. The proposed alternate self-shielding, however, requires no additional wires. We evaluate our method by simulating signal transimission with a circuit simulator. As a result, our proposed method is superior in bit rate compared to others from 10% to 75%.