Search

In this paper, we extend the interference channel with degraded message sets model by introducing multiple secondaries. The new model allows for multiple concurrent transmissions in a wireless network by employing dirty paper and superposition coding. We apply the proposed scheme to the communication between nodes in a wireless mesh network (WMN). The cases of different WMN topologies are analyzed, and numerical results show that considerable capacity gains are achieved when using the proposed model with multiple secondaries.

This paper investigates an optimization of the conventional relay selection for multirelay environments. In contrast with previously reported selection schemes, where a selected relay accesses the channel in a dedicated cooperative slot, the proposed scheme recovers the bandwidth loss of the half-duplex constraint by allowing two relays to simultaneously access the channels. Based on an appropriate dirty-paper coding (DPC) technique among relays, the proposed scheme enables a relay to establish communication with the destination at the same time that another relay forwards the data from the source. It is proven that the interplay between relay selection and the superposition DPC weight factor provides a tradeoff between relaying and new data performance. Hence, an appropriate codesign of the superposition DPC parameter and opportunistic relay selection can achieve efficient communication for the new data without affecting the relaying performance. The proposed scheme is compared with conventional relaying approaches, and its enhancements are provided through theoretical studies and numerical results.

Multiple-input-multiple-output (MIMO) systems are of interest for meeting the expected demand for higher data rates and lower delays in future wireless packet data systems. In such systems, it is optimal to simultaneously transmit to multiple users compared with a single user in a single-input-single-output system. In addition, multicarrier systems are of interest to combat frequency-selective fading that is experienced over the larger bandwidth that these future broadband systems will use. The use of dirty paper coding further complicates the matter, because the order in which the users are encoded will affect the rates that they can achieve. A well-designed cross-layer scheduling algorithm must take into account the multiple dimensions of this resource-allocation problem and other quality-of-service (QoS) parameters to fully exploit the communications channel. The scheduling problem is often expressed in terms of optimizing some utility function. Unfortunately, the search space for this optimization problem is extremely large, which prohibits an optimal exhaustive search. To this end, we investigate the use of genetic algorithms to reduce the complexity of the scheduling. This paper builds upon prior work that implements scheduling via genetic algorithms in the context of single-carrier systems using zero-forcing beamforming (ZFB). In this paper, we investigate how the genetic algorithm can be adapted to account for the effect of encoding order on the scheduling and how the scheduling can be extended to a multicarrier system. In particular, we investigate the maximum throughput and proportionally fair scheduling criteria. We demonstrate that the performance of the genetic algorithm is near optimal compared with an exhaustive search at a greatly reduced computational complexity. Furthermore, in the case of a multicarrier orthogonal frequency-division multiplexing (OFDM) system, an increase in capacity is shown relative to the single-carrier case.

This paper investigates distributed MIMO precoding design to maximize the weighted sum rate in a heterogeneous network where the multiple input multiple output full-duplex (MIMO-FD) small cells reuse the downlink spectrum of the macro base-station (BS) to exchange backhaul information. The multi-antenna BS transmits signals to the cellular users using the dirty paper coding technique and the MIMO-FD small cells apply FD precoding structures to effectively balance the received signal, the self-interference (SI), and the co-channel interference (CCI). Since the optimization problem is shown to be nonconvex, obtaining the global optimum is challenging. A low-complexity solution with distributed implementation is introduced with proved convergence. By applying the successive convex approximation technique and the duality between the broadcast channel and the multiple access channel, the original nonconvex problem is decomposed into a sequence of convex subproblems, which can be solved analytically and separately at each small cell and macro BS with limited channel state information exchange. Simulation results confirm the convergence and demonstrate the benefits of the introduced algorithm. It is shown that the SI and CCI can be suppressed effectively with sufficient cancellation power and number of transmit antennas at the FD small cells.

In rollover prevention systems, a real-time lateral load transfer ratio (LTR) is typically computed to predict the likelihood of a vehicle to rollover and, hence, initiate rollover prevention measures. A traditional LTR largely relies on a lateral accelerometer signal to calculate rollover propensity. A new predictive LTR (PLTR) is developed in this paper, which utilizes a driver's steering input and several other sensor signals available from the vehicle's electronic stability control system. The new PLTR index can provide a time-advanced measure of rollover propensity and, therefore, offers significant benefits for closed-loop rollover prevention. Simulation results are presented using the industry-standard software CarSim to demonstrate the benefits of the new PLTR index. Experimental results of open-loop comparisons between LTR and PLTR indexes are presented, followed by experimental results on the closed-loop implementation of a PLTR-based rollover prevention system. The results in this paper document how a predictive rollover index can be developed and the advantages of such a system in rollover prevention.

This paper discusses interference precancellation in digital hierarchical broadcasting (HB). In particular, we present the principles and implementation of structured dirty paper coding (SDPC) that approaches the capacity limit of dirty paper coding in multilayer broadcasting. As an alternative to Tomlinson-Harashima precoding (THP), SDPC eliminates the significant performance loss suffered by THP in the low signal-to-noise ratio (SNR) regime due to the modulo operation. The key idea behind the SDPC scheme is the exploitation of the modulation structure of interference, thereby simplifying the demodulation process in hierarchical reception. We exemplify the SDPC technique by implementing an SDPC-based HB system on a real-time test bed. The experimental results show that SDPC delivers the performance of ldquosuperposition coding with successive interference cancellationrdquo without extra computation or memory requirements at the receiver side.