Search

A load model is one of the most important elements in power system simulation and control. Recently, the constant impedance, constant current, and constant power load in combination with the induction motor load have been widely used as the composite load model, whose parameters are all identified from the field measurements in measurement-based load modeling practices so far. However, there is virtually no research conducted on whether all these parameters could really be identified. This paper investigates the possibility on reducing the number of composite load model parameters to be identified from field measurements. This paper first shows that direct application of the IEEE load motor parameters in the composite load model may be inadequate on describing the load dynamics over different operating status. Then the perturbation method is used to derive the trajectory sensitivities of the equivalent motor parameters, based on which the reduction on the identified parameters of the composite load model is presented. Two cases of measurement-based load modeling in North China and Northeast China are studied to illustrate the validity of the reduction method. It is shown that the reduction does not lose the model's capability on describing the load dynamics. The reduction on the number of identified parameters not only provides a possible way to solve the multi-valued load model problem based on the current practices on measurement-based load modeling, but it also facilitates building of the load model with more components included in it. Meanwhile, reducing the identified parameters reduces the identification time; thus, the proposed strategy significantly enhances the efficiency of the load modeling work. [ABSTRACT FROM AUTHOR]

Due to the uneven geographical distribution between load and wind power, currently it is difficult to integrate the large-scale wind power into the State Grid in China. There are significant wind curtailments for wind farms due to system restrictions. This paper proposes a new way of utilizing wind power, i.e., in-situ consumption, as an alternative to the costly development of long-distance transmission of large-scale wind power. Electrolytic aluminum load, which is one of the most typical high energy consuming loads, is employed to absorb the excess wind power in western China. An actual isolated industrial power system for aluminum production driven by wind power and coal-fired power is described. The penetration level of wind power in the isolated power system is up to 48.8%. The power imbalance between generation and load demand caused by wind power fluctuation or the tripping of coal-fired generators can dramatically impact the frequency stability of the isolated power system, which is of small inertia. An online identification method of power imbalance based on Wide Area Measurement System (WAMS) is presented. According to the characteristics of the electrolytic aluminum load, a system frequency control method by regulating the bus voltages of aluminum loads to eliminate the power imbalance is introduced. The simulation is done in Real Time Digital Simulator (RTDS) and the results verify the validity of the proposed frequency control method. [ABSTRACT FROM PUBLISHER]

Load model is one of the most important elements in power system simulation and control. Based on more than 20 years of practice using load characteristic recorders in the measurement-based load modeling, this paper proposes the Expectation Composite Load Model to predict unseen data. The methods for load bus classification and parameter identification are also provided. The generalization capability of the proposed load modeling is validated by the measured load dynamics and system dynamics during two three-phase short circuit tests of the NE power grid in China. In order to evaluate the measurement-based load model, the Probabilistic Collocation Method (PCM) is applied to quantitatively analyze uncertainties of the simulation responses raised by the parameters. [ABSTRACT FROM AUTHOR]