Search

In signal injection sensorless drives, the injection voltage cannot be reduced under a certain value. The lower limit of the injection voltage is mainly enforced by the inverter nonlinearity that causes distortion of the injection voltage and degradation of the position estimation performance. After analyzing the inverter nonlinearity during the voltage injection, it is revealed that parasitic capacitances of insulated-gate bipolar transistors have positive effects on inverter output linearity and sensorless control. Based on this analysis, this paper proposes a method to reduce the injection voltage by connecting additional capacitors to the output terminals of the inverter. Simulation and experimental results are provided to verify the effectiveness of the proposed idea. In the experiments, using the capacitor-integrated inverter, it is shown that the injection voltage can be reduced by more than half without degrading the position estimation performance. [ABSTRACT FROM AUTHOR]

It is important to improve the overall efficiency of a photovoltaic (PV) inverter when it is connected to the grid. Fundamentally, the conversion efficiency from dc to ac power of an inverter is important. However, in the presence of partial shading, maximum power point tracking (MPPT) on PV modules is more important than the conversion efficiency. In this paper, a new control method for a three-level inverter is proposed. With the proposed method, each dc-link voltage of the three-level inverter can be asymmetrically regulated. When PV modules are split into two and each split module is connected to the respective dc-link capacitors of the inverter, the asymmetric control can be helpful because separate MPPTs are possible. The effectiveness of the proposed method was examined through experiments with a T-type three-level inverter, where each dc-link capacitor was supplied by a PV simulator emulating two separate PV modules under different shading conditions. [ABSTRACT FROM AUTHOR]

The nonlinearity of an inverter could be regarded as the output distortions of the inverter. In this paper, voltages in a trapezoidal form were utilized to compensate for the nonlinearity of an inverter. Undesirable harmonic distortions in the overall system were mitigated through the modulating shape of the trapezoidal voltage. For trapezoidal modulation, a dedicated modulator was designed to facilitate adaptive compensation for a wide operating range. The compensation effects from the proposed method were examined in a practical system, in which a permanent magnet synchronous motor (PMSM) was driven without any position sensor. Additionally, it was shown that the proposed method could enhance the sensorless control of the PMSM by reducing the output distortions of the inverter. [ABSTRACT FROM PUBLISHER]

This paper addresses the inverter nonlinearity of a three-level T-type inverter. The main causes of the nonlinearity are pulse shaping, pulse skipping due to narrow pulses for the dead time, and voltage drop of the switching devices. Although the same causes have existed in two-level inverters, the pulse skipping phenomenon and results are quite different in the case of the three-level T-type inverter. The effects of pulse shaping and skipping have been investigated and discussed. In addition, the voltage drop of the switching devices has been considered in conjunction with the conduction path of the T-type inverter. Compensation methods based on the pulse width modulation (PWM) of T-type inverter to alleviate the inverter nonlinearity have been proposed from research results. The proposed methods could be easily implemented by adding appropriate offset voltages to the voltage references of the inverter in PWM. Furthermore, a neutral voltage balancing method of a three-level T-type inverter has been proposed in conjunction with the proposed PWM methods using offset voltage. Through extensive experimental tests, the fifth- and seventh-harmonic components of the current are conspicuously reduced along with the even harmonics. The neutral voltage of the inverter can be balanced effectively with the proposed offset voltage adjustments as well. [ABSTRACT FROM AUTHOR]