Search

Due to the unbalanced three-phase currents and the torque ripples and speed fluctuations to the drive caused by the current sampling errors of three-phase current sensors and corresponding signal processing circuits, the estimation on current sampling errors is of great importance to eliminate these adverse effects. The observer-based methods, however, present two defects: first, they could increase the computational burden to the drives, thus limiting their practical applications; second, their high dependence on the system speed or position feedback information might degrade the estimation accuracy. To solve these problems, this article proposed a fixed-point sampling method of lower branch flows and three phase-currents, which adopts the relations between the measured currents, rather than any complex algorithm, to estimate the current sampling errors. To coordinate with the proposed strategy, a fixed-point sampling scheme was accordingly rolled out. Compared with the observer-based methods, as a fixed-point one, much applicable to actual digital controllers, it could reduce the computational burden of the drive. Meanwhile, its effectiveness was verified by experimental results on a 1.5-kW IPMSM prototype, which showed accurate estimated current sampling errors and the effectively eliminated torque ripples and speed fluctuations. [ABSTRACT FROM AUTHOR]

In the control of permanent magnet synchronous machines (PMSMs), predictive controllers have received considerable attention due to the enhanced dynamic responses. However, periodic disturbances caused by dead-time effects and sampling errors deteriorate the performances of PMSMs. In order to suppress periodic disturbances, one typical control structure is to adopt several corresponding resonant controllers connected in parallel with the main controller. Even though excellent steady-state performances can be obtained, coupling effects between reference tracking and periodic disturbance attenuation can be observed, leading to significant transient oscillations under the situation of a reference step change. In order to realize decoupling between reference tracking and disturbance attenuation, this paper proposes a dual-loop predictive control structure, in which the reference tracking is only determined by the primary predictive controller. Periodic disturbance attenuation is achieved through an embedded disturbance rejection loop. By applying the proposed controller, periodic disturbances are strongly attenuated while smooth and fast transient performances are simultaneously guaranteed. Furthermore, a wide range of low frequency harmonics can be successfully suppressed, including but not limited to the main periodic harmonics. The steady-state performance, dynamic responses, and robustness against parameter variations of the proposed controller are verified through experiments based on a 2.3-kW PMSM. [ABSTRACT FROM AUTHOR]