Search

To achieve an individual and continuous power distribution for multireceiver wireless power transfer (WPT) systems, a novel multifrequency modulation method has been proposed. In the proposed method, a look-up table and delta-sigma modulation scheme are introduced to generate a mixed-frequency driving voltage pulse by synthesizing it from the given voltage pulses. The components of synthesized driving voltage pulse have continuously and individually varying amplitudes of multiple specific frequencies. With the proposed modulation method, only a standard full-bridge inverter is employed in the transmitting side to achieve power distribution among receivers, leading to a simple configuration of the transmitting source. Moreover, the proposed method has a small calculation burden and can be easily extended to the system with more receivers. When compared with the existing multifrequency modulation method, a lower switching frequency is obtained in the proposed method. Finally, the effectiveness of the proposed modulation method is verified theoretically and experimentally. [ABSTRACT FROM AUTHOR]

This article proposes a circulating current and second harmonic current (SHC) suppression method by introducing virtual impedance into the circulating current and output current feedback control loops of the dc solid-state transformer (DCSST). The virtual impedance is employed to adjust impedance in the circulating current feedback control loop to decrease the circulating current when the transmission efficiency of each dual active bridge is different. And a SHC suppression method, which introduces the virtual impedance containing a bandpass filter, is adopted to reduce the SHC and improve the dynamic performance of the DCSST. Moreover, a relatively independent modular control method, which is conducive to the modular expansion of the DCSST, is proposed. Compared with traditional DCSST control methods, the proposed method can simultaneously realize the output current sharing and effectively reduce the SHC with modular control. Finally, a DCSST prototype is built and the results of the experiment verify the validity and effectiveness of the proposed control strategy and solutions. [ABSTRACT FROM AUTHOR]

The droop control is an advantageous approach for stand-alone supply systems consisting of multiple batteries, allowing among various inverters without intercommunication. The droop coefficients of batteries always vary with their state-of-charge (SoC) and charge/discharge mode, resulting in small-signal instability. Nevertheless, the existing impedance-based approaches can only assess the droop coefficients stability point, but not the stability region. Therefore, this article proposes a droop coefficients stability region analysis approach. First, the charge/discharge SoC-based droop controlled battery, the P&Q controlled distributed generator and the constant power load are separately discussed. Meanwhile, the state matrix and return-ratio matrix are established, respectively. Furthermore, the novel forbidden region criterion based on the return-ratio matrix is constructed, which reduces conservatism compared with norm-based impedance criteria and partial forbidden region criteria. Such a forbidden region criterion is first switched to the Hurwitz identification problem regarding the equivalent return-ratio matrix. Combined the state matrix and the equivalent return-ratio matrix, the generalized incidence matrix is constructed to simultaneously identify subsystem stability and interactive stability. Based on the generalized incidence matrix, an adaptive step search strategy is proposed to obtain the droop coefficients coordinated stability region. Finally, the simulation and experimental results illustrate the validity of the proposed method. [ABSTRACT FROM AUTHOR]

Indirect matrix converter (IMC) is an alternative for ac/ac energy conversion, usually operated with a voltage stepped-down gain of only 0.866. For applications like distribution generation where voltage-boost functionality is required, the traditional style of operating the IMC is therefore not appropriate. Like most power converters, the operation of the IMC can surely be reversed to produce a boosted gain, but so far its relevant control principles have not been discussed. These challenges are now addressed in this paper with distributed generation suggested as a potential application. Simulation and experimental results for validating various performance aspects of the proposed control schemes can be found in a later section of this paper. [ABSTRACT FROM AUTHOR]