Search

A method for fault type discrimination and faulted phase identification using instantaneous local current measurements is proposed. Seven current components are obtained from the measured three-phase instantaneous currents through a transformation and band passed filtered to remove the fundamental components and high frequency content. Upon detecting a fault, nine fault discrimination indices are computed taking different ratios of the maximum rates of change of these filtered current components. The indices are used to (i) separate ground faults from the phase-to-phase and three-phase faults, (ii) discriminate phase-to-ground from phase-to-phase-to-ground faults, (iii) differentiate phase-to-phase faults from the three-phase faults, and (iv) identify the faulted phases. As the indices are ratios, decisions are less affected by the fault resistance. The algorithm was validated using a power system simulated in PSCAD/EMTDC. Extensive testing involving more than 10,000 fault scenarios showed that fault type and faulted phases can be successfully identified. The algorithm found some difficulty in identifying the phases involved in phase-to-phase-to-ground faults at certain fault inception angles, and one of the thresholds can be affected by the transposition scheme. [ABSTRACT FROM AUTHOR]

Directional, phase-selection, and distance elements of a relay are prone to misoperation in the presence of inverter-based resources (IBRs). To address these problems, modifications of relay elements as well as new control schemes for IBRs have been proposed in the literature. These methods focus mainly on addressing the misoperation of only one of the above relay elements. The available solutions that are based on a new control system focus only on the negative-sequence current loop. Thus, they work only for unbalanced faults. This paper proposes a comprehensive dual current control scheme for IBRs during all types of faults such that all of these relay elements operate correctly. The proposed method controls the IBR to operate as a voltage source behind a virtual impedance in the positive-sequence circuit, and a single impedance in the negative-sequence circuit, thereby emulating the phase angles of a synchronous generator's (SG's) fault current. The proposed method also maximizes the active, and reactive current generation of the IBR during faults, and emulates the incremental sequence current magnitudes of an SG. The proposed method does not require altering the relay elements. Moreover, correct operation of the relay elements is achieved regardless of the fault type, resistance, and location. The effectiveness of the proposed method is verified through not only simulation studies, but also hardware-in-the-loop testing of commercial relays. [ABSTRACT FROM AUTHOR]

Inverter-based resources respond differently than synchronous generation sources during power system faults, challenging line protection reliability. Part I of this paper presented cases that challenge line protection schemes. In this paper (Part II), we provide solutions that can be applied to gain a substantial improvement in reliability. [ABSTRACT FROM AUTHOR]

In order to accurately measure the impedance, the residual current for impedance measurement in ground distance relay is compensated in a fixed manner. It has been shown that the above compensation manner may have negative impact on the phase selection in mho elements in a single-pole trip scheme. A new residual current compensation method based on the magnitude of current of each phase for mho elements is presented in this paper. The performance of this new method is analyzed under all kinds of fault conditions. Simulation studies are carried out to investigate the new compensation method based fault component impedance relay in a typical transmission system. The relay has shown satisfactory performances under various fault conditions especially for the close-in ground fault and cross-country fault. This new compensation method can also be used in phase selector based on impedance measurement. [ABSTRACT FROM PUBLISHER]