Search

A symmetrical four-port microstrip coupler has been proposed for crossover application. Models have also been developed to provide insight into the performance of such a coupler, which is based on the double-ring design. Laboratory tests have confirmed that the measured isolation and return loss of the prototype coupler exceed 20 dB over a bandwidth of 20% (from 0.92 to 1.12 GHz). [ABSTRACT FROM AUTHOR]

In this paper, a new power divider concept, which provides high flexibility of transmission line characteristic impedance and port impedance, is proposed. This power divider is implemented on a parallel-strip line, which is a balanced transmission line. By implementing the advantages and uniqueness of the parallel-strip line, the divider outperforms the conventional divider in terms of isolation bandwidths. A swap structure of the two lines of the parallel-strip line is employed in this design, which is critical for the isolation enhancements. A lumped-circuit model of the parallel-strip swap including all parasitic effects has been analyzed. An equal power divider with center frequency of 2 GHz was designed to demonstrate the idea. The experimental results show that the equal power divider has 96.5% - 19-dB impedance bandwidth with more than 25-dB isolation and less than 0.7-dB insertion loss. In order to generalize the concept with an arbitrary power ratio, we also realize unequal power dividers with the same isolation characteristics. The impedance bandwidth of the proposed power divider will increase with the dividing ratio, which is opposite to the conventional Wilkinson power divider. Unequal dividers with dividing ratios of 1 :2 and 1 : 12 are designed and measured. Additionally, a frequency independent 180° power divider has been realized with less than 2° phase errors. [ABSTRACT FROM AUTHOR]

We report a novel technique for radiometric detection of radiation in the millimeter-wave regime based on optical modulation. Millimeter-wave energy modulated onto an optical carrier is detected using a low-bandwidth photodetector with optical filtering to suppress the carrier. Using this technique, we have achieved noise-equivalent powers as low as 20 pW√Hz for a 44-GHz narrow-band signal using chopping techniques. Such detection was implemented using commercially available components and without RF or optical amplification. Further improvements in sensitivity are expected as the setup is optimized for operation in the frequency band of interest. [ABSTRACT FROM AUTHOR]

In this paper, a new architecture for baseband digital predistortion dedicated to wide-hand transmissions is presented. The proposed predistorter consists of a cascade of a static lookup table-based predistorter and a subband filtering block. The subband filtering technique is used to improve the correction bandwidth limitation of conventional architectures. The cases of four- and eight-subband decomposition were considered and compared to the case where the fullband signal is processed. This revealed that the subband processing results in a better sensitivity and an independent tuning ability of the predistorter at each subband. In addition, it was shown that, in the proposed predistorter, the computational complexity and the required processing speed are reduced proportionally to the number of subbands. Moreover, in an adaptive digital predistortion context, a quicker convergence can be achieved. Experimental validation of the subband-based predistortion concept was successfully carried on a 100-W peak envelop power lateral double diffused metal-oxide semiconductor power amplifier. [ABSTRACT FROM AUTHOR]

A miniaturized dual-mode ring bandpass filter at 1.45 GHz with a bandwidth of 6% is demonstrated. The perturbation of the dual modes is realized by a pair of local ground defects. The miniaturization is achieved by loading the peripheral of the ring with the butterfly radial stub structure. A 41% loading factor has been achieved using this method. The simulated and measured results are in good agreement. [ABSTRACT FROM AUTHOR]