Search

An 8-pole 48-slot dual three-phase synchronous reluctance motor has been tested under half control mode, that is, when only a single three-phase system is supplied while the other is not operating. Changing the terminal connections of the motor prototype available, two different winding configurations have been tested. This allows their performances to be experimentally compared. At first, the cross coupling effect between the axis in $dq$ reference is analyzed, by measuring the flux linkages for different current combinations. The torque characteristics are compared in terms of torque map, maximum torque capability and torque ripple. Then the finite element analysis has been used to explain the experimental results and to investigate the radial forces on the rotor. Finally, the impact of a lack of symmetry between the two three-phase system is investigated. [ABSTRACT FROM AUTHOR]

Integral-slot electrical machines require modifications and optimization of both stator and rotor to maximize the machine performance. In addition, sub-harmonics in magneto-motive force distributions is an important issue in motors with fractional-slot concentrated windings. These additional sub- and super-harmonics increase iron losses, which becomes an even bigger challenge in high speed/frequency applications. A permanent-magnet (PM) motor with unbalanced winding (UBW) and unconventional slot numbers is a good option for applications that require smooth torque output and low back electromotive force voltage harmonics. In this paper, different winding configurations and displacements of an unconventional nine-phase PM motor with both balanced fractional-slot winding and UBW structures have been investigated. The focus has been on 117-slot with 12-pole (for the balanced winding motor) and 36-pole (for the UBW motor) combinations. Motor prototypes with UBW configurations have been manufactured. The finite-element analyses results have been validated with experimental results and it is shown that such unconventional slot/pole combinations can be a good option for some high-power applications. [ABSTRACT FROM AUTHOR]

This paper proposes the novel scalable saturated model of synchronous permanent magnet machines, which combines ultrafast scaling laws with a saturated flux-linkage and loss model. The scalable model is used for the fast and accurate calculation of efficiency/loss maps and can also be used for drive cycle analysis including the calculation of energy consumption. It is verified by comparison with an existing state-of-the-art efficiency map and drive cycle analysis software. Additionally, an experimental verification of a saturated flux-linkage and loss model is presented. The additional possible usage of the scalable model is to find the optimal size of a scaled machine in order to meet the drive cycle performance and requirements of a traction motor. [ABSTRACT FROM AUTHOR]

It was recently demonstrated that the synchronous reluctance motor is well suited for electric as well as for hybrid electric vehicles. This paper deeply investigates the capabilities of a synchronous reluctance motor and compares them with those of a permanent-magnet-assisted synchronous reluctance motor, according to the typical requirement of a traction application. A proper rotor design is necessary. The average torque is due to the rotor anisotropy. The permeance difference between the direct- and the quadrature-axis is achieved by means of a high number of flux barriers. The position of the flux barrier ends and proper rotor asymmetries are chosen so as to reduce the torque ripple, mainly due to the slot harmonics. The impact of the rotor design on the motor performance is presented deeply, showing several simulation and experimental results, carried out on synchronous reluctance motors with different rotor geometries. Permanent magnets can be inset in the flux barriers to assist the synchronous reluctance motor improving its capabilities, but avoiding to use rare-earth permanent magnets. The main advantages of the permanent magnet assistance is an increase of the main torque density and of the power factor. They are evaluated experimentally. However, the drawback of adopting permanent magnets is the possible demagnetization of the magnets themselves. This can greatly limit the maximum overload capability of the motor, which is a salient requirement of a traction motor. [ABSTRACT FROM AUTHOR]